Many thanks for both items - much appreciated! Cheers James JB out and about

Hi all I just got a message from Klaus-Peter Renner at EUMETSAT that the new downlink will start next week. But the first week of June they only do transponder tests. The signal will not yet carry

Ian and James I have a Triax TD110 (110cm) dish here properly aligned to Eutelsat 9A. My TBS-6925 can still lock DVB-S2 transponders 8PSK with up to 74.3Mbps TS traffic with BER=0 on Eutelsat

To be honest James I think it will be very difficult to get both 9E and 10E on a 100cm dish -- it needs to be smaller. However as you rightly say the existing alignment is critical. If it is

Correction: Then up on the flat roof with the laptop - if David has released his neat tool by then. I see it is a Space-band product. Apologies for any confusion. James

Many thanks for that Ian - possibly the extra 8cm made a critical difference if it wasn't simply an issue with the Technisat software. I imagine the 100cm dish will be a fraction more critical again.

Hello James. With regards to the dish alignment, when I was visiting Douglas a few weeks ago we were able to pick up a TV station on Eutelsat 10A with his dish which is 80 cm. If I remember

Good morning to all. A few 'curiosity' queries. 1. Test transmissions of the new service have been scheduled as starting in early June. We are not far from what might reasonably be classified as

Hello Ernst and David, At work we use Zenoss for querying hundreds of devices using SNMP. It uses a central server on Centos or other Linux and uses mysql database. It can be scaled to monitor

From: James Brown satellite@... [MSG-1] Not sure where my previous posting went - but sorry if this is a repeat. My SR1 either by default or by use of the Eumetsat configuration script

Hi Arne! Thanks for your reply. I bought the TBS-6925 im April 2014 direct from TBS. So I think this is the latest model. My chipset drivers are up to date. I run an "almost new" ASUS Sabertooth

Hello Ernst and David, At work we use Zenoss for querying hundreds of devices using SNMP. It uses a central server on Centos or other Linux and uses mysql database. It can be scaled to monitor

Hello Harmut, I have run TBS ip tool 3.0.3.9 on W7 x64 and have not seen these problems. But I run a TBS-6925C version card. I do have lots of error messages in Tellicast log ( disconnects and

Not sure where my previous posting went - but sorry if this is a repeat. My SR1 either by default or by use of the Eumetsat configuration script had traffic and management connected via

many thanks David ciao Alberto Il Martedì 27 Maggio 2014 19:43, "Alan Banks alanjamesbanks@... [MSG-1]" Ooops That needs sorting! Alan

Ooops That needs sorting! Alan

Hartmut My receivers all run under GNU/Linux. So for Windows I can only ask to check the obvious. Do you have the latest drivers? Google found this: TBS6925 Linux Driver is updated to v140425.,

Hi Ernst! It is diificult to explain, but I can change all parameters and items in TBS-IP-Tool and suddenly the DVB-card shows 100% signal and the data stream interrupts. Especially when I

HI All, I'm trying to understand the operation and settings of the Ayecka SR1 in preparation for the change from DVB-S to DVB-S2 but I can not understand the difference between management and traffic