Graham The TBS-6909 does NOT work for EUMETCast! You need a TBS-6909X. This latter card comes as TBS-6909X V11 built 2018/2019 and as TBS-6909X V2 built 2020. Mike and I tested the TBS-6909X V11 in

=============================================================================== John to be honest this news is almost irrelevant. In all my time with Eumetcast going back to Meteosat 6 I have never

=========================================================== John I wouldn't call it wonderful news for those of us up north as the chances of Hotbird 13 ever being used for Eumetcast are next to

Hello All, OK, OK! I should have read the EUMETSAT notification properly. Damn, damn, damn, again. If EUMETSAT are reserving these two transponder on Hot Bird instead of 21 E, wouldn't it be better to

Hi Ernst What is the difference between the TBS 6909 and the TBS 6909X V2 or would either do Regards Graham

Hello All, I meant to attach the new downlink power level plot many of you will enjoy in my last post. Goodness, here in southern England the predicted power level will go up from 48 dBW to 53

Hi Proper Job Never got my signal above 12db with my 110cm down here in Cornwall Jan Sent from Mail for Windows 10

Hugo and All, Damn, damn, damn, This is wonderful news for 'those up north ' and in Ireland. But my SNR with a 1 m dish and SR1 on TP 1 has been 'quite high' over the last few weeks at 13.3 dB to

Hi All That's good news for all EUMETCast reception stations in the U.K. (in case of an Eutelsat 10 failure 13°E is certainly far better than 21°E). It's even more good news for people using TBS

Hi, News : https://www.eumetsat.int/migration-eumetcast-europe-restoration-capacity-hotbird-13 grts, hugo

Hello Ian, Not sure what you mean with file extensions. It depends on the satellite which kind of image is transmitted. For example Metop and Meteosat has a proprietary file structure, FY-3D is HDF5,

================================================================================== Many thanks Hugo. All seems to be working well. The Oblique Mercator Projection works well with VIIRS M and MERSI

Hi hugo new to all this ,could you please tell me what the file extensions namesect are for images this software works with,connected to eumetcast ,and very impressed with the images you are producing

Hi, In this release I solved some bugs for MERSI images and added a new Projection.Beside the Lambert, the Perspective and the Stereographic projections I added the Oblique Mercator Projection.This

Hugo, I'll check this. The executable on my webpage is not ment just for one distro; it works here also on e.g. Fedora. (A matter of used kernel, not distro, I think.) I just

Tim, If I were checking that I would look to see what "localhost" points to on your PC, likely in windows\system32\drivers\etc\ "hosts." You can edit that file with notepad as you may already know.

All, My reception and display of Eumetcast output is and was working properly. But my Tellicast monitoring (localhost:8100) was not. When my browser is asked to display localhost:8100 it displayed

Hi Rob, Ubuntu dropped since 18.04 the i386 architecture. I don't think that many people are still using 16.04 ... Kind regards, Hugo

Graham You can temporarily change the log_level in the WEB interface. A permanent setting must be put in the client *.ini file (needs a client restart). Make sure you have a "log_file=>>path to your

Hi Ernst I have done that but my logging level was set to quiet I have set up three instances so will see what happens tomorrow Regards Graham