Hi Your signal seems to be good, but i can see there are some power lines blocking your antenna beam which certainly is less good. And YES if you feed the dish motor via the TBS-card DiSEqC you should

Hi, I have a TBS-6903 dual port card in a fairly hi spec PC (i7 8086K@5Ghz, 32Gb ram, 2TB SSDs and a 8tb NAS). I have a 1M dish (on a motor) and am getting 98% signal and 78% quality from Eutalsat

HI I have a TBS 6903 card I and can use it to grivr the dish motor. Haven't beed able to turn to other satellites yet

Hi, I have a TBS-6903 dual port card in a fairly hi spec PC (i7 8086K@5Ghz, 32Gb ram, 2TB SSDs and a 8tb NAS). I have a 1M dish (on a motor) and am getting 98% signal and 78% quality from Eutalsat 10A

Hi This is the view with my mobile taken on top of the LNB And the Signal that I am getting

Hi All Not sure I found the original post of this thread: As George is talking about a TBS-card chances are that cornishman68 uses such a card to? If so and if you feed your dish motor via the RF

======================================================================= I had a motorised dish many years ago used for TV, before the days of EUMETCast. It was installed by a professional ( probably

Hello, Hope you don't mind me adding some info. I've been using a TBS 6903 for reception, initially with a 1m Gibertini dish, using an Inverto RED Extend LNB (pretty generic). According to Eumetsat's

Jan, Thanks for the further information. I suspect you may be the only user whose dish is mounted on a motorised dish system. I've no experience of these systems but presume that when they are

Folks, A reminder that we have what should be a most helpful resource in the EUMETCast Wiki: http://eumetcast.pbworks.com However, this has been sadly neglected and is now in need of an update to

Hi I am using a Technomate TM-2 I think I aligned it as best as i can. I Set the motor and dish pointing South and the elevation I adjusted when it was locked on to EUMetSat 10E I will post a

Hi Douglas Thanks for the link I notice the data is now coming through again Kind Regards Graham

======================================================================== No problem Graham. You will find the information here :- https://www.ospo.noaa.gov/Operations/messages.html Hope that

Hi Douglas Thanks - I thought it was my system . I dont know why I always think its something Ive done!! Can you point me to the NOAA site where you saw that announcement - I couldn't see anything on

==================================================================== Yes it is the same here Graham. The following information from NOAA :- Topic:GOES-R Data Outage on ESPDS/PDA Date/Time Issued:

Hi I have just noticed that there doesn't seem to have been any GOES16/17 data since about 12:30 Is that the same for everybody - I cant see any announcement in the UNS Regards Graham

Hello Cornish man, I think you too have a problem. You, like me, are inside Eutelsat-10's max central power contour - though a bit further west. With a 1.1 m dish you should be getting far more

Roland, Yes, there is definitely something wrong with your system. Gibertini dishes are widely accepted as having 'the best' RF performance. And as others have said your SNR - and, I would also say,

Should be OK since 11:05. MSG2_RSS was mapped to 0 instead of 9,5 east. Rob.

I have noticed that with the changeover this morning from MSG3 to MSG2 the RSS data is not remapped to the correct longitude. This highly disrupts all services running on RSS. This has been notified