Hi John No I cant get it to run either and I cant roll back my version either Just have to hope CrazyCat is following this thread and can fix the problem Regards Graham

hi My mistake earlier. I am on windows 10 not windows7 but still have build 19041 so hopefully should be still ok regards philip

I would prefer the author's source: http://crazycat69.narod.ru/sattelite/DVBDataEx/bdadataex.htm http://crazycat69.narod.ru/sattelite/DVBDataEx/BDADataEx-setup.zip

Hi mmmm I think i am lucky. My satellite computer is using windows7 . My build is 19041. regards Philip

Graham I hope you have better luck than me! Regards John

Hi John Thats bad news !! I am on that build and have just ordered a PCi card to run that very software Regards Graham

Dear All, I doubt that there are many of you who are involved in Windows Insider. However, let me issue a warning. Builds 21277 and 21286 prevent the functioning of BDADataEx and TBS-IPdata. I

Hi David Thx. I will print the manual out Is this the best site for downloading the BDADatex software https://bdadataex.software.informer.com/download/ thx Philip

Looks like the next upgrade for HVS-3, 4, 5 and 6! Cheers, David -- SatSignal Software - Quality software for you Web: https://www.satsignal.eu Email: david-taylor@... Twitter:

An interesting experiment, but I share Ernst's doubts! Prove me wrong! David -- SatSignal Software - Quality software for you Web: https://www.satsignal.eu Email:

Philip, Yes, nothing to alter in the SR1 configuration. As I said at the start, there's no single "correct" way to do this, particularly if you have a PC with no PCIe slots (a portable?) or you

David, this has been running several months here under GNU/Linux. And as I also demonstrated you will still have a demodulator left for coming HVS-3 as the TBS-6909X can cope with 4 transponders of

Hi David On the PCI Express website under the drivers tab there is a download for a TBS6909XChangeModeTool.exe which I assume will do the same I wont know until my card arrives on

Thanks, I wasn't aware of that, good, but putting all your eggs in one basket. Does CrazyCat's SR-test.exe do the required internal linking or is there a newer version? Excellent idea on the use of

David, I'm aware of that , but the point is that with a very cheap RTL-SDR he is able to receive and decode some kind of data protocol (IP over DVB-S2 ? ) with a Raspberry-pi. The bandwidth will be

David I have purchased those DC blocks . i might as well use them..they do not cost much thx Philip

Can't speak for the 6909, but with the 6903 you can use one antenna feed, switch it internally to both receivers (CrazyCat software), and then it looks like two devices and requires two copies of

Hi David I thought ihad finalised my decison . I think i will still go this way though and just ditch the TBS software and instead use BDADatex software for the TBS card. I presume you keep the

David, the TBS-6909X can replace 3 SR1 TC receivers. So probably 3 TAP network adapters. As I just stated some posts down the road: ... demodulator 0 takes Basic Service T1 with MODCOD filter set,

I would get a 2-pack of F-type DC blocks as well - just in case they are needed: https://www.amazon.co.uk/Ancable-F-Type-Voltage-Blocking-Capacitor/dp/B07CNKQDMD Admittedly they don't get a good