John, I downloaded and installed this update today (after setting a System Restore point!) and had no problems with the restart. Best regards - Alan

problems (Windows XP) tried adding to the boot file, the very last line, /pcilock - according to Microsoft knowledge base this can help with PCI IRQ conflicts. Didn't know about that one, James.

(without waiting for some eumetsat messages) ? I would love to see a real-time Web page with this information - how about it Eumetsat? Not that I know of. wait for them. my image processor is

--- In MSG-1@..., "Peter Benney" <tugboat@g...> wrote: [] > I had bad segment loss today on the 0200, 0215, 0230 cycles and the 0245 cycle was reported missing. > > The Tellique log

--- In MSG-1@..., "David Strickland" <David@s...> wrote: [] > Final thought of the day but I have yet to check it out. I know we are well out of the equinox but several times I have

Folks, Today I changed the SkyCard drivers on my main Receiver PC from V4.2.8 (as supplied with the V2.6B DVB card) to the earlier V4.2.2 drivers (as supplied with the V2.3 card). There are two

So far this morning (and also some of yesterday evening) I have not seen any holes in my images. There has *always* been a hole in the 9.45am HRIT image set - but not today. Long may it

Hello all , can anyone tell me the best way to pay for my software to EUMETSAT, I would like to do by VISA but on my invoice there donsn't seem to be anyway off doing this. Thanks Barry

Hi, how can i figure out, which skystar card version i am using? regards, max

All those in the UK looking for dish wind tests should not be disappointed in the next few days....assuming you can find them afterwards !! Looks particularly nasty for the west. Regards Douglas.

I might be lucky, up to cycle 2300 I had not a single segment missing today ! Running receive-only on PIII @ 1 Ghz with 256 Mb mem./ 40 Gb disc / 100 Mbit NIC W2K sp3, Skystar v2.3 SQ=70%, driver

Just to cheer up all of those who have had problems - today I had only two segments reported missing, and they were there anyhow! So perfect reception after a week of misery. Robert Quoting James

Another least affected operator ( I think ) reporting another good day. MSG DMG report attached,its easier than typing.Notes added where appropriate. Norton has scoured for the little blighters, so

Thanks Douglas for the longevity perspective! I still can't bear to part with the photo machine I built, nor the frame store which handled 16 image animations with 256 grey-levels, and had pixels that

I am one of those who seem to be least affected by the problems in MSG reception, so I just wondered if folk would be interested in seeing the log file for today thus far. It covers the period of

Hello Max, Don't be fooled by the lower signal quality. The new Skystar rev2.6B readings are simply lower compared to the old rev2.3 card. This reading is a calculated value, it is not calibrated

David, I had bad segment loss today on the 0200, 0215, 0230 cycles and the 0245 cycle was reported missing. The Tellique log shows a mass of "missed messages" and several error messages... "Failed

wrote: seach David, Final thought of the day but I have yet to check it out. I know we are well out of the equinox but several times I have lost segments on bright clear sunny days with no wind

hi everyone, since some days i have some troubles getting all segments. the specs of my receiving system are: 1.2m kathrein dish 2.4Ghz 1GB Ram 160GB HD winxp pro tellique 2.3.0a skystar 2 dvb card