I just checked signal level of my DVB and it 60%, as usual. I live near Milan and my dish diameter is 60cm, transparent plastic esternally. I can not say anything else, since I just sent my request

Douglas, I've just switched on my rx PC and data seems to be flowing OK here Dave (Isle of Man)

Back on but from experience you may need to re-boot in the correct sequence if segment loss is to be avoided. The outage was about 10 mins with some questionable in/outs just prior to that. Douglas.

Unless some unexpected has happened at this end it looks as if the 11096 transponder is down. Red icon on the taskbar for the DVB but only on that frequency and TV channels on that transponder also

Hi MSG'rs have segments 2 4 5 6 7 8 are missing, segment 3 has the first few lines missing and the 0830 cycle is missing . HRV all except 1 and 2 missing. > Looks very similar

jkelly@... writes: Jeff, Someone in EUMETSAT has successfully used the TechniSat SkyStar 2 PCI (see Timestep advertisement in the September RIG Journal) to receive the C-Band

have segments 2 4 5 6 7 8 are missing, segment 3 has the first few lines missing and the 0830 cycle is missing . HRV all except 1 and 2 missing. > Looks very similar here..... The Tellique log

David, I have this but on the 0815 cycle where all HRIT/LRIT channels have segments 2 4 5 6 7 8 are missing, segment 3 has the first few lines missing and the 0830 cycle is missing . HRV all except

wrote: MSG than David, this is the expected behaviour from the current version. It was processing the 0815 cycle, data for which stopped in the middle of the scan. When data for the 0830 cycle

David, My collection computer has been running since late Friday 10 October. The computer that runs MSG Data Manager was turned on yesterday ( It is used for other jobs with occassional bursts

Oh, well, that's right up-to-date! I'm adding more protection to the program against bad segment data which the Tellique software sometimes seems to emit, so perhaps it may not happen in a future

v.1.2.4.236 Signals restarted 20:00 last night here. John

From: Dave Cawley Timestep Dartmouth England e-mail Information@... Web site http://www.Time-step.com Tel. +44 (0)1803 833366 Fax. +44 (0)1803 839498 John Din and I are going to try this

PC. That explains why FSD also stopped. OK, that makes sense. Presumably, what you were trying to achieve was to get the FSD, but not the unwanted LRIT data from MSG-1? There doesn't seem to be a

David, I took the LRIT PID out to reduce hard drive usage on my receive PC. That explains why FSD also stopped. Many Thanks, Paul

Hi All, Configured Interface as 192.168.0.5 and Tellique now works correctly...how does this work...anyone? Now to re-configure MDM on the XP Pro machine...I know it's the middle of the night,

Hi All, Oh am I having problems here! I have swapped over to a two PC system, having XP Pro on one machine and 98SE on another. The intention being to collect raw data using Tellique/98SE and

way Jeff, I can't tell you much more than is in the RIG Journal. You saw the comments on dish size, I expect. You would need to get a username and password from Eumetsat, so I would suggest

After reading the RIG article and living on the US east coast, I am interested in setting up a MSG system. Is anyone receiving this way yet? I could use a little help on this type of receiver and

to MSG Manager appeared: .. and what version of the MSG Data Manager? I haven't seen that problem here. Still getting ADMIN messages, foreign satellites etc. Cheers, David