Hi, here in western part of Germany i have a very stable signal. No lost packages etc.. Ciao Flo

Hello Mario, There was a period of 'instability' a few weeks ago but this has been rectified by the EUMETCast uplink provider. The reason for the problem appears to be unknown. I've seen very brief

Hello everyone, I need some information: due to the bad weather of the last few days in Italy in my area, the dish has lost alignment with MSG. I have read on some posts that currently the MSG signal

Thank you all, yes I had tried the Telnet option from PuTTY, which came up with an error message "Network Error; connection refused"; and, having searched the oracle, the

Yes, John, the requirement to activate Telnet twice is confusing! You can, of course, use any Telnet program, from anywhere on your local network. As I was concerned about retiring one PC (portable,

Terrence and David, David, you may recall I had problems with accessing PuTTY some time ago - which had worked for many years. Apparently the same problem as Terrence(?). Something like 'can't connect

Terence, You can always [try to] access the device with Telnet on its management port - e.g. with PuTTY. You just need to find its IP address. This doesn't need the serial port. You may also have

Thank you both Ernst and David, when using PuTTY to check the SR1 configuration as suggested, I was presented with an "unable to

Terence and David, yes indeed according to the SR1 Manual F) LNB Power lets you select OFF, 13V and 18V (18V needed for H). If this does not work maybe setting up the second plug RF2 for EUMETCast

Terence, Yes, there is a configuration setting in the SR1 to enable/disable the LNB voltage. Configuration, Choose the Active one, F: LNB power, I think. If not, you can get a TBS-5925 or 5927,

Thank you Ernst, I will investigate the possibility of an uncalled for Rx configuration change. As far as a replacement receiver is concerned I am, unfortunately perhaps,

Hi, It's now 8 year back that I ran an SR1 as a pilot user for EUMETSAT. I do not recall whether it was/is possible to configure the SR1 for no output voltage on RF plugs. So as a last try (you

Ernst, I had indeed first checked the voltage in the cable end nearest to the LNB, but I then removed the LNB cable from its RF1 connector at the SR1, fitted the short test cable

Hi Does this mean you checked on the LNB side of the cable? If yes, unplug the cable at the SR1 side and directly measure the voltage at the SR1 RF plug (the cable could have a short cirquit). IIRC

Hello all, perhaps someone could offer advice please. A few days ago I lost signal from my Ayecka SR1 Rx. The receiver appeared all correct except for the red locking LEDs. Suspecting

Hello All, This is getting ridiculous! With last Sunday and today, weather related, I've now lost my EUMETCast data more times than in the last year - or more. And for quite long periods - and lock at

Ti ringrazio oggi ho parlato con eumetcast domani mi aprono goes 10 ti ringrazio ancora delle dritte io all'epoca avevo attivato tutto ma magari le registrazioni con aggiornamenti vari si erano

Per l'MSG Animator, ti consiglio vivamente di utilizzare un Mini PC che esegua unicamente quel programma e prenda i dati da cartella remota. Il software deve attingere ai dati senza appesantire già

SSD da 500 gb e 8 gb di ram ma secondo me non e la ram ma l'accesso al disco credo.....

MSG Animator manda in palla il disco c ma e normale? provato anche ad abbassare i frame ecc ma niente succede anche a voi?