Ernst, I set up my Technisat HD USB box again but the CrazyCat fix SS2XPFDX.ex will not load on my computer with the message it has stopped working. I have tried all compatibility ( I am running

Eventually I reinstalled the client software and the EKU. I get a nice pink T and it starts to join the usual channels from receive channels. ini. They register as active then go to connecting. A few

Eventually I reinstalled the client software and the EKU. I get a nice pink T and it starts to join the usual channels from receive channels. ini. They register as active then go to connecting. A few

Enzo, Francois Roland has pointed out that I made an error in describing how to use the site drossel-services.de. I had not understood that the satellite Eutelsat 10E is in fact also known as

Bonjour Fran�ois, Vous avez raison. Je savais que le satellite en question pour les transmissions DVB S-2 est 10 Est, mais je ne savais pas qu'il a aussi le nom de W1 (et aussi 4A!). Donc, il

Thanks David, I'll do that and report back. Regards John -- Sent with K-@ Mail - the evolution of emailing.

Thank you, I appreciate the offer and I will be in touch. Kind regards, Basil

David, Yes I have checked that. Could it be that the Ayecka needs up-grading? Regards, Basil ==================================== No, there should be no need for an upgrade. If you have TeamViewer

OK David, thanks for the information. Regards, Basil

.. further, there were two interruptions to TelliCast yesterday at 13:35 and 14:36 for over three minutes each time. One of these events may have been the trigger, although I didn't see anything

David, Yes I have checked that. Could it be that the Ayecka needs up-grading? Regards, Basil

I did not think the wind had been that strong! Loosing packets by the 10's of thousands, Es/No still good at 11.1 dB Log file latest: MSG:2014-12-18 15:20:10.967:Channel "TSL Announcement Channel":

Hi Christoph, I've changed the coax cable from RX1 to RX2 but the light doesn't change, it is still red and there is no difference in the main

Hi Christoph, I've changed the coax cable from RX1 to RX2 but the light doesn't change, it is still red and there is no difference in the main menu. Regards, Basil Hi Basil, change to DVB-S2.

I did not think the wind had been that strong! Loosing packets by the 10's of thousands, Es/No still good at 11.1 dB Log file latest: MSG:2014-12-18 15:20:10.967:Channel "TSL Announcement

Ian As reported several times the TechniSat Skystar 2 eXpress HD and the SkyStar HD USB DVBS-2 box do work under GNU/Linux for the Basic Service even if they do not know about VCM. It's one single

Hi Basil, RX1 and RX2 designate the receivers, i.e. where you plug the coax cable coming from the dish into. The data stream still arrives at RX1 even with configuration set 2; unless you switched

Geoff, I have a Technisat HD USB DVB-S2 box the same as the one shown on the migration page. It will not work under Windows for the basic service as it is not compatible with VCM . You can receive

Hi Basil, When you select the channel to be active you must also go down the menu I think to the letter( I ) To make it active check before you do anything but is quite clearly labelled in the

Hello Allan I do not believe, On the menu: which satellite you want to receive: the names of the satellite with the ( -** ) is situated to the East the names of the satellites with ( ** ) is situated