Hi Folks, I am trying to setup my new Windows 7 64 Bit PC. Installed the Drivers Card. Installed and set the Setup4C to receive EuroBird 9. I get the icon Green. Installed then the EKU Software and

Are you converting the data into an imprecise data type (such as 8bit int)? Depending on the scaling you apply it could be that the values in that region (~350K) are too high for the data type and so

Nick, Unless you are using an inverted palette, black on a IR image translates into hot, not cold. It looks to me as a small hot spot, probably a fire as suggested by Terence, but it is odd that it

Are you converting the data into an imprecise data type (such as 8bit int)? Depending on the scaling you apply it could be that the values in that region (~350K) are too high for the data type and so

Yes, not sure how I got hot/cold inverted :-) Regards Nick

Nick, Unless you are using an inverted palette, black on a IR image translates into hot, not cold. It looks to me as a small hot spot, probably a fire as suggested by Terence, but it is odd that it

Nick, it looks rather as though it's a quite serious fire near the border. It shows up very well on the fire-monitoring animation. Regards, Terence

Evening all, Any one else see the _very_ cold (black) area in NE Portugal in the last few IR images? Very obvious in Channel 4 from about 18:30 to 19:15? Also on several other wave-lengths but not

Thanks Rob, Yes I did know that, it's just that I think I'm on Hotbird but I can't find any sign of a signal just to the west of it but there is another strong signal to the east of it (Astra 19

Tony, You mentioned Hotbird a few times. Please note that you need Eurobird, at 9 degrees east, not Hotbird! (Changed some years ago. Rob. tony_ei8jk schreef op 2012-09-11 17:45:

Sorry David, I didn't pose my question very well. I wondered if the signal strength/quality is derived from the digital stream as I note that the Hotbird digital stream on 11977 MHz is a different

Hi David. No I'm not sure I have the dish correctly pointed, that was the gist my question ... is it possible to get an on screen signal strength with those parameters from Hotbird ? If you can,

Hi David. No I'm not sure I have the dish correctly pointed, that was the gist my question ... is it possible to get an on screen signal strength with those parameters from Hotbird ? If you can,

Hi the group After an absence of several years I am trying to get my system up and running again. So far without success I hasten to add and was wondering if I am on the wrong satellite. I have loaded

Hi the group After an absence of several years I am trying to get my system up and running again. So far without success I hasten to add and was wondering if I am on the wrong satellite. I have loaded

Hi Lawrence, You and me both! I am up and running for the first time since last October with my Eumetcast.Problem is, I'm in a listed building and no antennas allowed. I got round it by Hiding a 80cm

Its been a long time - several months - but my MSG system is finally back in operation. The original problem was the receiver which failed, and possibly the LNB. I bought new both. After considerable

In message <337EA86B0D054DB5A1435660C27FA1CA@Alta>, David J Taylor <gm8arv@...> writes Thanks for the heads up David - My first time on the board there, so well worth it just for the

A reminder that the next EUMETRAIN Weather Briefing is at 0900 UTC tomorrow. You can attend free, and book a place by visiting the calendar on this page and clicking on Aug 14, and completing the

hello all ! Can someone help me please ? I received all Data MSG Metop regularly.I moved the dish in another position and I have now bad images in MSG Data manager, in Metopand AVHRR. The ramdisk is