I've fiddled with mine, especially on some scenery, and I view it as a supplement to a good airbrush with adjustable pressure source. In my case I have a nitrogen tank and 2-stage regulator for most

Leave the decoder address on default 3, use program on main to set desired sounds and lights. No acknowledgement required (from motor) and you'll hear/see changes immediately. Tom -- McLean

Just put a resistor across the motor leads so it thinks there is a motor. Set the speed to zero. lloyd lehrer 310 951-9097 -- lloyd lehrer

Thanks for the info. I knew in the back of my feeble mind there was a reason to ask. The 100 ohm resister is the solution, I needed. I just totally forgot about the ACK Thing. Thanks, so much,

Just wire A 100 ohm resistor across the grey and orange wires. Additionally you could set the three speed settings to zero. They’ll ack and you’ll be able to programme them. mark

Put the compressor someplace outside where it can make all the nose it wants, then run a quarter inch water line from there to where you are with fitting on it to accept the compressor at one end and

They won’t be able to ACK back To the programmer when trying to programming them so it will think it failed to program. Other than that it should not matter.

Now before you all jump on me and say “Go to the DCC Group” hear me out, please. I have 2 early Hallmark 2-8-2 engines. They both have mechanical problems that will be more trouble than they

George, Another possible On3 site to contact is: https://groups.io/g/On3yardsale Mark Lewis Narrow gauge modeling in N.C.

On3@groups.io On30conspiracy@groups.io -- Mike Conder

The weakest link here is the airbrush. For detail work it's not very accurate, you cannot alter the needle size/ nozzle for real detail and as for air control any airbrush allows you to control the

On3 Io group Please include prices on all items Send me your list as well. Darryl Huffman hobbydvds@... You can see samples of my work here: GhostTownModels.blogspot.com

Ric Case EBT Modeler Hamilton Ohio 1-513-375-7694

Best wishes to all. Wish I could be there. Please send pictures and have fun for me. Take care. Lee Gustafson Sent from the all new AOL app for iOS

^— no objection there… P.S. I may have a module or 2 there also… John Massura

Hi, all, In a shameless act of self-promotion, if you are attending the NMRA National Convention in St. Louis next week stop by the large Mudhens HOn3 modular layout, which will be on display all week

Clearance card? -- Nathan M. Kline Nate's HOn3 East Broad Top RR & Coal Co. ___________________________________ YouTube: https://www.youtube.com/channel/UCVJMoICFWw9Muse6xm8moiQ MeWe Group:

Thanks again Harry. I’ll try to make it then. Jim

It was just all humor and a play on words, sorry to the thin skinned that were offended.

Hey, no political in this forum please