Re: Uintah 2-6-6-2T


Climax@...
 

Excellent work.  I bet it was scary to take a drill to the model to begin with but it turned out excellent.  Congratulations on a fine job. db

-----Original Message-----
From: Paul Sturtz
Sent: Jun 17, 2018 7:05 PM
To: HOn3@groups.io
Subject: Re: [HOn3] Uintah 2-6-6-2T

Dave
Here is the final result.  Not as difficult as I thought it would be.  I used 1/16 alum tubing drilled out with a #57 bit.  I'm satisfied with the results.
Paul

Join HOn3@groups.io to automatically receive all group messages.