Re: Grab iron spacing from body

Mark Lewis

Unless the grabs were made of Colorado mined "unobtainium". Then only 1 was required.

Mark Lewis 
Narrow gauge modeling in N.C.

On Fri, Oct 2, 2020, 12:27 AM claneon30 <chrislaneon30@...> wrote:
It’s five.

Chris Lane - Editor HOn3 Annual

On Oct 1, 2020, at 9:49 PM, lloyd lehrer <lloydlehrer@...> wrote:

How many threads should show on bolts would be the next critical issue to resolve.

lloyd lehrer, (310)951-9097

On Thu, Oct 1, 2020, 8:47 PM lloyd lehrer via <> wrote:
I concur between 2.96" and 3.04" depending on stamped washers or cast washers.

lloyd lehrer, (310)951-9097

On Thu, Oct 1, 2020, 7:59 PM <Climax@...> wrote:
I think it looks better at 2 15/16ths

-----Original Message----- 
From: Dusty 
Sent: Oct 1, 2020 8:26 PM 
Subject: [HOn3] Grab iron spacing from body 

I've been setting my grab irons out from the box car car sides using .030 x .060 styrene strip in various lengths for spacers. According to the chart on the Evergreen package that's 2 5/8 ". Does that sound about right?

Dusty Burman
623 261-8707

lloyd lehrer

lloyd lehrer

Join to automatically receive all group messages.