Re: [HOsteam] Taking a Athearn Genesis pacific apart

Roger T

I just uploaded a new file about improving the Athearn Genesis Mikado's
performance by Dr. Wayne from While it goes much beyond what you
are requesting it begins with removing the mike's shell which I hope will be
pretty similar to removing the pacific's shell also. Hope it helps.


It would be really helpful if people posted links to the files rather than just posting, "I've uploaded a file....."

Posting a link take seconds and is very helpful.

Just sayin'

Having said that: -

Disassembly instructions follow:

The boiler isn't easy to remove but it does come off.

1) Remove the screw up through the cylinders and into the smoke box.

2) Release the cab using a small blade to release the tabs
at the back wall of the cab and on the sides of the firebox
near the front corners of the cab. Release the cab grab
irons from the "buffing plate"

3) Remove the cab.

4) Remove the smoke box stays from the pilot deck and
smoke box, remove the steps and running board from
the pilot deck and above the cylinders.

5) Lift the back of the firebox end of the boiler until it clears
the top of the motor. It will clear, just be firm with it, it's
a VERY tight fit.

6) With the firebox now clear of the motor, GENTLY
squeeze the running boards near the motion
bracket (To release another set of clips inside
the boiler) and at the same time GENTLY twist the
boiler to the left and slide it forward.

The boiler should now slide away from the chassis and not break off what I think is a mechanical lubricator on the front right hand side of the boiler.

Reverse this procedure, which is just as awkward, to reassemble the
locomotive. I've done this to both my 2-8-2s. Be VERY careful with
the motor wires, they break away from the tabs VERY easily.


You may as well do the following while it's disassembled to improve
the tracking and pulling ability:-

Add lead behind the smoke box door. As steam in the 50s didn't use
the headlight in daylight, I removed the wiring for this and used the
space for more lead.

Fill the steam dome and sand box with lead shot.

Remove the cylinders and fill them with lead shot, leaving room for the
piston rod to slide in and out.

Permanently remove the screw that goes up between the cylinders into
the firebox and fill the steam chest with lead.

Remove the lip from the wire opening in the tender.

Cut off the sleeve on the wiring harness and removed the 2 or three
wires that are not used from the wiring harness.

Remove the pressure springs on both the leading and trailing trucks.

Install a working front coupler.

Removed the "stepped" stack and replace it with a brass casting.

Both of my Athearn 2-8-2s will now out pull the Bachmann 2-8-0s on any
of my grades.

Roger T.

Join to automatically receive all group messages.