Paul You can disconnect both ends I think about 50 cm long. Dirk on4ct

Noel I waited also years to install solar panels. After studying the rfi issues on internet, a good source is the rfi forum on contesting.com Some advice : avoid micro inverters on the panels some inv

Jorge in rtty-l mode , the 101 is in FSK mode. in data mode , the 101 is in AFSK , the program gives the audio tones. I do not know what parameter has to setup in the MMVARI program. I use mmtty for t

Mike 5k is indeed a hight amount. I suppose the contractor will reroute cables and put on ferrites. I think you have to check the guidelines of Solar Edge company , maybe the contractor did not the wo

Inigo Thanks for this information. Does this works also in cw /rtty/digi modes ? Dirk

Mike The RFI generated by the solar farm is coming from the inverter(s). if every panel has a so called micro inverter then you have to choke every wire to it, Those wires are the antenna for the nois

I just wonder who writes such updates. Is it written by Yaesu software writers or the cheap way by external contractors. I did not install the newest version yet. 73 dirk on4ct

Derrick in the manual is an example how to connect the quadra. The layout of the 15 pin outjack is explained in the manual. The band data 2 of the quadra needs tx gnd, gnd, band data a b c d the alc p

Peter The 200w section is totally different than the 100 w assy. Cooling fins are bigger in the 200w Cooling fan is also different. Best viewed in the technical supplement , downloadeble from mods.dk

Bill I forgot to mention, With the 101 no interface needed between pc-tx, The usb connection does it all. If you have already one , you can sell that one. dirk on4ct

Biill Yes , about the same price. You will have a 200 watt , well built and good receiver. Am coming from a 5000D , the most step forward with the 101 is the spectrum screen, the an effective vc tune

Rick The pins 2 and pin 3 are used to ptt the amp. pin 11 the tx req : when this pin is shorted to gnd , the tx goes in transmit. on the 15 pin output jack are 3 GND pins , you can choose to solder th

Ken I have no other high end transceivers than the 101mp, before it was a 5000. I run also contests mostly in cw and rtty. With this rig I won the last cq ww rtty category classic low power. I is inde

Ron With or without a capacitor ? Dirk on4ct

Did you use capacitors over this speaker ? I think original there is a capacitor used . Dirk on4ct

Walt There is a good document in the file section wich explains the virtual ports. You can get rid of the connections to an interface by using the virtual ports, all digi modes -even the good old scho

Angelo Indeed very strange power drop. As Franco has been writing in data mode , it could be from audio setting. In FM you must have steady power. I should suspect a bad solder point/cable connection

Lou thanks for the information. Is this with the standard hand microfoon SSM-75G ? dirk on4ct

Alan There is lot to read about this subject, even in the file section you find information about this topic also form an Alan ... Brown. Dirk on4ct

Dave nasty experiende wth an new mp. Check also the 50 V DC power supply. Since only the tx is dead, the finals needs 50V . You can press the mox , set the meter on Vcc and see if the the needle hits