I know it sound dumb but make sure the VFO is not set to an OUT OF BAND frequency. This will cause the TX light to flash red as you indicated. 73, N1UXA

I have a 101D and that happened to me as well. TX blinking and couldn’t transmit. I was within the ham band. I also had the 101 lock up on me at other times. Pressed everything in sight and nothing

I think it’s hold fast and lock while powering up. Carl Yaffey K8NU 614 268 6353, Columbus

Good morning! Had the 101mp power down while on vacation. Went to start the radio today and I can’t get the radio to work. Receiver works, but the red xmit indicator is blinking. Can't get to the

Barry, Thanks for the post. The issue here is calibration - an accurate (true) measurement of the parameters of interest. Neither the FTDX101 nor the MNFJ 989D have been calibrated for your experiment

Actually, I have a K4 on order, and will sell the FTdx-101MP if it ever shows up. Meanwhile, the primary radio remains the K3. 73, Scott K9MA

Hello group! I have the Yaesu FTDX 101MP and a using the Vibroplex INRAD DMS-1 desk microphone and looking for preferred setting in the Yaesu FTDX101MP. I will readily admit I do not have an

This video will guide you through the upgrade. https://www.youtube.com/watch?v=ZPecN7bh5xc

Ok on that Doug , I thought they (K4) were being shipped out now.. I know I could be dead before I get a response from Scott to any of my questions. Setting the max power has many benefits including

Yes, but the 20% loss would not be detected by the rx station, so not worth the bother. vk4tux

I normally use my FTDX101D with a Heathkit SB220 amp. I also have two scopes, a Kenwood SM220 and a Heathkit SB610. Because Field Day rules say a 1D station cannot use more than 150 watts, I shut off

Ditto!!!!! 73, Morgan NJ8M BS + MS + $2.98 = COFFEE Real Life Experience = Priceless, says the man who set his back yard on fire with a breadboard tuner loading a 160 meter inverted L with 1000 watts.

I could be dead long before a K4 would bedelivered. Elecraft clearly 'overhung the market' on this rig. Doug Free Climbing - The ultimate test of strength and technique.

I agree 100% with Don. When my FT-1000D went belly-up during Museum Ships Weekend, I broke out my K2 "backup radio" and used it. The K2 is a good little radio, but nothing like the 1000D. Then my

Yes. Having AGC slope and threshold would be a very welcome addition to the rig. As with other radios that don't have these controls, two things that can be used to influence AGC to a degree are RF

Boy after using the ft -101d for a couple weeks now, mostly ragchewing in cw. Yesterday set my K2,a battery and a end fed wire at 15 feet and a paper log, to work emergency communications FieldDay.

Quite helpful for someone who’s had the rig for a year as well Laurie G3UML

You can set the AGC time constants, but not threshold or slope. 73, Scott K9MA

Agree. I appreciate the approach and presentation of information. I can see where it could be quite helpful for someone starting out with the rig. IMO, it's not authoritative and comprehensive and

Even Yaesu doesn't clearly explain the amc/mic gain.