Replying to my own message. Someone contacted me off list and confirmed the same problem. Doing a full reset allows the RTTY TX to properly work from the FH-2, but temporarily. I can confirm this.

Hi Rien, I agree that the previous messages were not helpful. Let me try: my FT-1000MP Mk 5 had a tune function (at lower power) that was accessed by pressing "TUNE" on the FH-1 remote keypad. The

Hi Cordiales, Tnx for this helpfull information (not) This is a very nice group very helpful people with nice information tnx for that all Rien, PA7RA

RTFM😁😁 Cordiales 73 Jean-Gabriel - F5PNI Send from Nokia 6.1

Hi. A question: in my old ftdx 3000 I used a specific tune power set in menu while it tuned with my LDG 600. In my ftdx 101 is possibile do same configuration? “Ci sono tre tipi di Uomini: i vivi,

Hi, All Yaesu transceivers work on same schema, like the 5000. Cordiales 73 Jean-Gabriel - F5PNI Send from Nokia 6.1

Good morning, Since a few days the proud owner of a Yaesu FTdx101MP. What I am looking for is the following. Before this I had an Icom-7610 and also worked with an external tuner and an LW. If I want

Trying to get the radio to transmit RTTY correctly when in the decode screen using the FH-2 remote. If I'm not in the decode screen it appears to work. I programmed buttons 1 - 5 on the remote. If

Correct - I'm using a stereo plug wired per the manual.

I need to correct a typo on my previous post: I should have written Region C2 rather than C3. So it should read: "What/where is Yaesu's Region C2? That is (as an example) -- would shifting a radio

What/where is Yaesu's Region C3? That is (as an example) -- would shifting a radio sold in IARU Region 2 to Yaesu's Region C3 REMOVE any frequencies authorized in some regions but not all, such as 1.8

you can not use a mono plug from your win keyer to radio it has to be a trs 1/4 inch plug and you use the tip and sleeve to connect to radio the mono plug will act as a short and create your problem

the manual as usual leaves a lot to imagination. The rear panel jack shows eithe straight key or key paddle since your external keyer is generating the morse you need to wire the plug like a key not

Bonjour, C'est à essayer, mais vous risquez d'avoir des problèmes de compatibilité de communication entre le PC et le transceiver. Autant utiliser un PC équipé d'origine d'un port USB. Même

-- Bonjour pensez vous que je peux utiliser un adaptateur DB9 VERS USB pour piloter le FT 101D 73 de f1ubw

Simply look at the files section, look for the document of G4IRN. No mars mod needed... 73 Michael

Yep, I think you are correct. You'd think they would hire some "foreign" (i.e., non-Japanese) consultants to advise them when they're designing (or finalizing) a new radio. I like the MARS idea, and

The Japanese designers are a little behind the times it would appear. Then again, after the warranty period you can simple perform a MARS mod and operate the radio as you see fit. Thanks for the

CORRECTION: On the 101, the 60m band operating parameters are set, and cannot be "adjusted". The two options are: USB or CW-U on each of the five allocated frequency "channels". The last ten FTDx

As discussed earlier, you have to use one of the radio’s memory channels. ( In this case #3) The CENTER freq of that channel is what your radio will indicate though you WILL transmit on 5357.0. The