I’d like a list of what it fixes or changes. 73 Carl Yaffey K8NU 614 268 6353, Columbus

Во время передачи на спектрограмме нужно установить уровень -20 дб

You can use a SDR Online to monitor your signal. You will see how your real signal looks like. 73, Maximo De: FTDX101D@groups.io <FTDX101D@groups.io> en nombre de Macy monkeys

The ‘101D spectrum scope is useless for determining TX bandwidth. So are 50% of reports given on the air :) John K7FD

Been there and done that. After lots of adjusting those settings, looking at graphs on Audacity, audio quality reports from others, and if other people can’t see it any splatter or signal on both

If you see your signal at both sides during USB/LSB then you need to adjust your mic gain, AMC and PROC. 73, Maximo EA1DDO

I, too, was very surprised to see my signal on Tx. It looks like I'm splattering all over the place, not staying "on my side" of the carrier in SSB. However, other stations have confirmed that my

All, Sad thing about the whole thing is that Yaesu could have used an attenuator switched in during transmit to cure this issue. This may have sacrificed the accuracy of the y (vertical) axis

New FW for FTDX10 released ==> FTDX10 Firmware Update 202112 (12/27/21) YAESU FTDX10 FW UPDATE LINK who knows if the expected update for the FTDX101D / MP should come out in the next few days.

All the above are great tips. One question, Giuseppe: do you have a FTdx101D for which you are using a separate power supply, or do you have the FTdx101MP with Yaesu's power supply that is included

Hi Chris WN2X, I too tend to keep my display at 50K width in the 2D mode as it allows me to really see faint signals when "level" is used correctly. Like you, when transmitting on SSB I was a bit

Maximo, Thank you. I’ll pay closer attention and check that. I’ve had the radio 6 days and it’s complicated. I don’t have the behavior on my 3000 and have performed (attempted) the adjustment

You need to pay attention to the bandwidth on screen during Tx, because it is different than Rx. I meant, you can keep 50K on Rx, but during Tx it will change to something else. I use to keep

I use a Sandisk 8GB. Make sure the disk is unlocked. It is a little slid switch on the side of the card.

Good evening, There was an unusual visit by me to 10m today during a brief opening. While transmitting CQ on ~28.3 MHz, I noticed while using the waterfall scope with a 50k width, my signal appeared

It said tested cards to 32gb. In JA speak, that means larger ones won’t work K5FUV Sent from AT&T Yahoo Mail for iPhone

Also, any CAT commands on the USB/serial port can also be used to turn the radio off and/or on. In case there is some other program running on an attached computer. Doug

Make doubly sure that power connector to the back of the rig is snug. Mine was problematic. John K7FD

I had such a problem on transmit, as Astron 35 Amp supply was susceptible to RFI and dropped voltage on keying. Switched to 50 Amp and problem went away, but still notice 2 volt drop on FT7250 2 meter

It sounds like a power supply voltage drop. 73 de NØIGU Jon