I'm soliciting inputs for your favorite digital tuner under 400. Favorite can mean whatever is important to you - Sound quality, DX capability, looks (for Jim), or sophistication of design on paper

Mike - Interesting news. I still think the automotive OEM market will decide the fate of IBOC. So far, it seems they (carmakers) will be more interested in other cool things, like GPS driven real

Hi Mike, Thanks for the input. At what point is the 350 kHz measured, -3 dB, - 6 dB, or ? Do you know what the peak separation on the discriminator is? John

Ryan; Great to hear this worked! I'll remember to scope this and takes pictures when I do my KT-8300. DIY amp builders will be familiar with the selection of these caps bypassing the feedback

just tried this on my KT8300. fixed the high speed whirring that was active whenever there was a stereo signal (this problem was a result of upgrading IC 11 & 13 to BB2604 opamps). oh btw, check AC

Hello group: I'm not an FM tuner expert by any means, but have been following many of the threads here on FMtuners for several months, particularly to learn more about the performance of analogue

Would like to hear from folks who actually own this tuner what their experiences are and how they would compare it to prior-owned supertuners. Accuphase sort of reminds me of the japanese tandberg in

about supply) of seen soft or either, sides of the the foil particular top side). probably for microdrops points very sides of the except for something factory coating and gooey factory

Guys: From this weeks "Radio World": Ibiquity Digital Corp will be rolling it out at the 2002 NAB convention. 3 transmitter manufacturers- Harris, Broadcast Electronics, and Nautel, will be

hi john, did i ask ya if ya have compared these to the b261, as far as sonics go? i have a b760 in the basement that has yet to get hooked up; i yust today was the high bidder on another one from

In a message dated 4/5/02 5:51:05 PM Pacific Standard Time, blundry@... writes: << al, as I'm a little confused about a few of the controls. I'd also like to hear about any firsthand

In a message dated 4/4/02 10:14:48 PM Pacific Standard Time, newaag@... writes: << 20kohm. You want to try soldering a 10 to 100 pF cap directly across the leads of these 4 feedback

In a message dated 4/4/02 3:27:19 PM Pacific Standard Time, jbyrns@... writes: << 1.) Are all six filter modules identical, or are there several different types used in the tuner?

In a message dated 4/4/02 12:59:21 PM Pacific Standard Time, charlesp@... writes: << ded to remove the bottom metal cover and > take a look inside. Well, looked like every part and

In a message dated 4/3/02 6:42:15 PM Pacific Standard Time, charlesp@... writes: << IMPORTANT, DO NOT USE ANY SORT OF CHEMICAL IN A TUNER (until receiving further instruction...)!

Matt: Yes, it sounds like a front end problem. DO NOT even attempt to open up and/or spray the front end or clean it. If you use the wrong cleaner, or get it into any of the trimmers in the front

There is nothing sticky or gooey on the bottom side of my TU-9900 either, though the boards do look shinier than from the top. The bottom sides of the boards are covered in a hard shiny green plastic

sticky Sounds like some one has sprayed a coating on the bottom, that was incorrect. It is typical that boards are "sealed" once built and tested, to seal and preserve the copper/tin plated traces

This is for Ryan, and others upgrading op amps in the KT-8300 If you are experiencing problems with new high speed op-amps, you may want to try this. Problems could be ringing, whirring, high

Hello John, All six modules are identical. Do not know the freq response characteristics. Best regards, Paul Bigelow individual