Bonjour Martin Avec ta solution le graissage se fera même si la machine ne bouge pas donc? Les valvules sont des doseurs qui se "chargent" quand la pompe tourne et libèrent leur quantité d'huile

I also have the same machine however I do not have the ACC. As far as I have found it requires the WinNC software, MSD disk, and appropriate licenses to function. I have yet to successfully run mine.

David, it looks like I have the Funac O version. Thanks,

Here is a partial scan of the ACC Retrofit instructions. Sorry about the pour QC.

Thanks a lot. I have my ACC without cables, so I need to create those cables myself, looking forward to your manual. Arjan Op di 11 aug. 2020 om 19:40 schreef Joe Y <kasanay@...>:

Hello, I have the Installation/ conversion instructions For the MCC. I will see if I c as n get them uploaded later today. I’m also happy to take pictures. Thanks, Kasanay

Welcome to the club. You indeed need a PC with EMCO software (hope you have some licenses). I have the ACC box but I really like to see detail photo's of your cables, because I did not attach it

I had one of these conversions with the ACC electronics. They charged like $ 4,000. for the upgrade. You will need to use the ethernet cable to another PC and have the operating system of choice

Hello, I just joined and I don't want to high jack anyone's thread, but this one seems to fit my needs, quite well. I recently hauled a PC Mill 55 home from an auction where it did not sell. It came

Salut Jacques Je viens d'installer une minuterie qui est complètement autonome du LinuxCNC et qui met en marche la pompe chaque fois le relais d'arrêt d'urgence est réinitialisé et alors après un

Hi Dieter, Thanks for your message. Whatever the circuit is it is not doing anything. 16 Volts appears on the transistor but the transistor is never switched on, I have removed and checked it. I have

Hi Keith, Your schematic looks like a switching power supply: https://en.wikipedia.org/wiki/Buck_converter Dieter

Hi All, I have added another photo to the album. The photo shows a sketch of the 5 Volt supply on the interface board. I believe that the component in my photos marked PJ220 is I think an encapsulated

Bonjour Martin je possède aussi une VMC, en cours de rétrofit car la TM02 incomplète est inutilisable, ton idée est simple et acceptable à mon avis. Je pense que commander le graissage en ce

I have mine installed on a Pentium II. The most important thing is that the computer does not have a built in video port. This causes conflicts which cannot be overcome easily. Look for a computer

What kind of computer are you trying? It does not seem like the smartest thing to install it on a 486. That will be painfully slow Op do 6 aug. 2020 om 09:31 schreef Constantine Christophi

I think the Windows 98 disc is not a real critical boot disk. Just open the ISO in windows and copy the content should be enough. Op wo 5 aug. 2020 om 23:47 schreef Baschwar@ <baschwar@...>:

Hi, I had similar problems so l bought a drive off ebay. CD/DVD drives are widely available and are not expensive, I got mine for £9.99 free p+p. Ed

Hi All, Windows 98 as far as I can remember came in two parts one floppy disk and one CD. The floppy was the startup disk. I think the later versions Windows 98SE may just have been on CD. The startup

I had great difficulty in finding the floppy version of Windows 98, the solution I went with was piggybacking an internal CD ROM drive set to slave on the same IDE cable as the hard drive and