Re: Software for Compact 5 PC


notewell48 <notewell@...>
 

--- In Emco_cnc_users@..., "nikko2one" <nikko2one@...>
wrote:

Hi everybody :-)
- yes it's true; i'm a little embarassed. After my last posting
here, I've realized that there was the "Files"-section with some
software in.
- BUT still: I agree with Nigel... -It would be very helpful if
there was a general introduction to people like me, who finds a
compact 5, but don't have any knowlegde or other information on how
it is intended to work. - Information like: How do I set it up,
which software and platform do i need, is there any alternatives,
differentiation between models (ex. in features), other advices,
and so on...
So far I've realized that i might need a DOS platform to use the
software on, and hope i'm right on that.
-But if you have any suggestions or advices, I would be very
pleased
to hear from you.
The maschine I've found has 16 G-codes (acc.to a manual sheet that
followed the maschine), is in very good condition, and seems to
vork
just fine. (But has not been able to connect it yet...)
I hope to be able to make arcs and L/R threading on it. -Is it
possible?
Best regards to you all! Nik :-)
PC % manual available here

http://finance.groups.yahoo.com/group/Emco_cnc_users/files/

Nigel

Join Emco-CNC-Users@groups.io to automatically receive all group messages.