Re: 4 Jaw chuck to fit EMCO CNC5


Alison and Jim Gregg. <ajgregg@...>
 

Hi.

The EMCO 5CNC  does not have a threaded spindle nose, but uses an oddball DIN fitting where a recess in the chuck backplate pushes onto the spindle nose to locate it concentrically, and is held in by either 3 or 4 screws - (3 or 4 jaw chuck), through the front of the chuck into the end of the spindle. 

It's a good arrangement in that the chuck cannot unscrew itself, but is a bit harder to find, especially generic ones - been there done that!

Jim Gregg.


At 03:55 AM 14/07/2006, you wrote:
Anyone advise where I can get a 4 Jaw chuck to fit the EMCO CNC in the
UK please?  Thread sizes might help locate a generic one?

regards Roddy






------------------------ Yahoo! Groups Sponsor --------------------~-->
Check out the new improvements in Yahoo! Groups email.
http://us.click.yahoo.com/6pRQfA/fOaOAA/yQLSAA/LdmwlB/TM
--------------------------------------------------------------------~->

 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Emco_cnc_users/

<*> To unsubscribe from this group, send an email to:
    Emco_cnc_users-unsubscribe@...

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 

Join Emco-CNC-Users@groups.io to automatically receive all group messages.