Date
1 - 6 of 6
KAT500 not recognized
|
mike@...
Using the latest update from Elecraft and connected via the Elecraft USB/232 cable to my MacMini M1. i can get the unit recognized but when I try to see what software is on the tuner or try to upload the new file, I get a KAT500 failed to enter firmware load" error message. Any ideas? The tuner will not hold swr... it tunes my G5RV fine but then goes out of resonance with a lot of clacking noise... if I tune and turn it off, My K3S holds resonance fine...
|
||||
|
|
||||
|
I had a similar problem with my macbook pro updating my PS. I switched to a PC. No problems upgrading. Hope this helps you get the latest firmware.
On Sun, Oct 10, 2021 at 1:27 PM Mike Wendland <mike@...> wrote:
--
73 Mike N6YSK And any man who may be asked in this century what he did to make his life worth while, I think can respond with a good deal of pride and satisfaction: "I served in the United States Navy."
|
||||
|
|
||||
|
Mike Wendland <mike@...>
Cant switch to a PC... need it to work on my Mac mini with the M1 chip Mike, K8ZRH
On Mon, Oct 11, 2021 at 8:45 AM Mike Rees, 2004 SYA 40' 71616 <n6yskmike@...> wrote:
|
||||
|
|
||||
|
Richard Smith <ku4nz01@...>
You can load VMWare on Mini and run Windows and a virtual machine. RAS KU4NZ
toggle quoted messageShow quoted text
|
||||
|
|
||||
|
David Fleming
There was a problem with the new firmware file not loading properly with the Mac Utility. Here is link to to a new version of the Utility that should correct the problem. This version is not yet published on the Elecraft web site.
|
||||
|
|
||||
|
Just use the PC to upgrade the firmware. I use my mac to control the radio.
On Mon, Oct 11, 2021 at 5:55 AM Mike Wendland <mike@...> wrote:
--
73 Mike N6YSK And any man who may be asked in this century what he did to make his life worth while, I think can respond with a good deal of pride and satisfaction: "I served in the United States Navy."
|
||||
|
|