Date
1 - 3 of 3
K3 to Mazzoni Loop Controller
|
David Bondy G4NRT <david@...>
I want to connect my K3 to my Ciro Mazzoni Baby Loop ATU v2.0 via an RS232 to RS232 cable.
I know that the loop controller has a setting to allow it to receive frequency change commands from Elecraft rigs but I do not know how or where to set the rig to send these commands via the RS232 connector. If anyone has done this and can advise me then I would be most grateful! 73 de David G4NRT |
|
|
|
George Pappayliou
Love the antenna but I have been unsuccessful in getting it to auto tune to track my K3s. I have tried a variety of hook ups off of my P3. I know that the frequency information is there because it auto tunes my SteppIR Urban Beam without an issue.
toggle quoted message
Show quoted text
If you find an answer please post a follow up as I would be interested to give it another try. ------------------------------------ George S. Pappayliou On Jul 12, 2020, at 11:18 AM, David Bondy G4NRT <david@...> wrote:
|
|
|
|
Randy K7RAN
I'm wondering if anyone has an answer. I recently purchased the Elecraft-to-CiroMazzoni serial cable, but I also can't figure out how to make it work.
|
|
|