[Elecraft_K3] VFO-B tracks VFO-A on 12m only


william conkling <bconk75@...>
 

Press and hold the SUB button to un-link the VFOs.

...bill nr4c

On Jul 29, 2011 8:28 AM, "John" <qrz@...> wrote:
> Hi
>
> I have a slight problem, I'm not sure if its a K3 configuration issue or a software bug. Setup is K3/100 with Sub-receiver; firmware 4.36;2.73;1.14.
>
> On 12m, in any mode, if I turn VFO-A knob then the sub receiver frequency display follows VFO-A. It tracks up or down at the same rate as VFO-A but always keeps the offset that I started with. If I turn VFO-B knob, the frequency is independent of VFO-A i.e. it doesn't happen in reverse. This happens whether I am in split mode or normal mode.
>
> This doesn't happen on any other band, leading me to believe its a config problem but I haven't a clue where to undo the setting.
>
> Any help appreciated.
>
> Thanks
> John G4IRN.
>
>
>