I saw many hounds calling him, watched the decoder for over an hour before I finally started decoding him. I just wasn't hearing him. Once I did hear him, I called for 90 minutes straight before he wo

So you heard a rumor and decided to bash them without cause or evidence. Dennis NJ6G

I have DVR messages saved into M1-M4 on the K3, pressing F1 plays M1, F2 plays M2, etc. Really no setup required, it just works. From the KPod manual: Store the macros you wish to launch from the K-Po

How are you transitioning from the coax to the end fed? If the antenna is connected directly to the jack on the K3 then the counterpoise would be necessity be connected to the chassis at some point. B

How are you getting your xmit audio into the K3, and what is you Mic set to? Dennis NJ6G

Are you using a data cable other than the one supplied with the K-Pod? I ran into issues when I tried to use a longer generic cable. Keyed the mike and watched the frequency drift while I was speaking

I created a K4 subfolder in my email program and set a rule so anything with K4 (or K-4) in the subject gets deposited directly into there. 73, Dennis NJ6G

Oooh, I could use that. "Alexa, please tune to the noontime net." "Alexa, get me on the Rotuma Island spot (turn antenna, set mode and split, turn on amp.)" 73, Dennis NJ6G

Even with shipping to the Netherlands? Dennis NJ6G

To download and install the K3 Utility on your computer, no the radio does not need to be on. The radio does need to be on for the utility to communicate with your radio. Dennis NJ6G

I don't that's what was meant. I read it to mean that the power level indicated 150 even though the power was probably set at whatever was proper at the point he stopped turning the PWR knob. I haven'

Check your Config - Speaker setting? Dennis NJ6G

Usually. The first one they sent me didn't allow band switching from the KPA500 so they had to send me another one. And don't get me started on why they haven't yet figured out that you can't properly

I'd recommend the N6TV Y-box for connecting multiple items to the Acc port. http://www.kkn.net/~n6tv/Y-BOX/ 73, Dennis NJ6G

There's really not much more to it than that. To decode RTTY on the K3, with no PC, set the Mode to Data, and select FSK-D using the DATA MD button, and select 45. Set TEXT DEC to ON. I have the thres

What does it do if you remove the SVGA board entirely? Dennis NJ6G

The ACC connector is made accessible by adding the Y adapter E980190. 73, Dennis NJ6G

K3, not K3S? If K3, what is your sound card? 73, Dennis NJ6G

I'm running Windows 10 and have never had a problem with adapters using the FTDI chipset. That is also the chipset recommended by Elecraft. I'm using two different brands but don't recall off the top

Thanks, I'll give that a try. 73, Dennis NJ6G