Ok, That is good. Now, if you click "options, then RF front end configuration" you will get the option to tell it to use the IF signal from the SDR controlled by Omni-rig. That should get you there.

Derek, After you installed the EXTIO software, you were instructed to copy the EXTIO_rsp*.dll into the HDSDR directory. IF you did that, you should get the SDRplay control panel when you click on SDR-

Derek, You are very close to having it sorted out. It works FB as you say, HDSDR, OmniRig, and RSP(duo in my case) The RSPduo can read the IF output directly and there was no need to configure anythin

Glen, Could your roofing filter configuration be wrong?

Hi all, This is probably a dumb question but the manual doesn't indicate if the serial cable for updating the firmware etc on the internal 2m transverter is specially wired or not. I have several 3.5m