I think it is the computer operating system which likes to go back to its factory set default. The Flex Radio SmartSDR has the same problem and the developers seemed, at least in Windows, to concede t

Mine does not come on occasionally. I have looked at 1) when shutting it down, make sure you switch it to standby first; 2) you may have to hold the on button down for a second or two; 3) sometimes I

Thank you IK4EWX. Grazie. I did find some interesting info on the sites you shared. I found my answer there and now have all the keys of the K-Pod programmed for each band CW. nz2z

What is the command to program the K-Pod F Buttons to set a different frequency for band?

Thanks everyone. I have set rP.H with the bias on. The XLR pin 2 is the tip of the 1/8" jack and the other 2 pins are connected to the body of the 1/8'. Checked the Heil site and used their settings.

I have a Heil PR-781 connected to the rear ⅛” slot on the back of the K3. I set the menu for the RP and bias off. I sent the EQ as follows: 1 - -16 2 - -8 3 - 0 4 - 0 5 - 0 6 - 0 7 - +3 8 - +6 The mic

Thanks, but I need to wire connect them. Bob/nz2z

I tried the RP, both Hi and Lo and with bias and without Bob/NZ2Z

Has anyone connected the Heil PR-781 to the rear mic port on a K3? I have tried but am not getting any output. I followed the pin out for the XLR, 1=ground, 2=hot(+ve), 3= cold(-ve) and on the stereo

Pete, I hear that they are not going anywhere anytime in the near or distant future Bob/nz2z

I have been going to Dayton off and on for many years. Hara Arena is not the best, but they have few other options. The Nutter Center provides a nice arena, but the semester is not over, so there is n

I have a K3 inline with the KAT500 and KPA500. When I turn the amp to OPERATE it attenuates the received signal from S9+15 to S6. I have wired according to the diagram on page 5 of the Tuner's manual,

I'm a new K3 user. I have 8 working HF radios and I compare them from time to time. The K3 is an excellent radio, but does not hear as well as the FT-2000 which sits below it on my table. But these ar