I just submitted and it went through fine. Mel, K6KBE

I agree, and the settling time is the caps charging from the DVM. Mel, K6KBE

I have been in the situation where I needed more power and decided that the BEST solution was to go 12 or 24 VDC battery with solar and trickle charger backup. With adequate planning, a >1 KW SSB DC s

As one who has seen the worlds fastest fuses go bang, the causes maybe many. Usually the higher VDC at load will not necessarily blow them unless it exceeds the max level by a considerable about. They

Anyone know of any Apps for the Kindle Fire for the above? Mel, K6KBE

The correct place for this is at nabble wish list. Then leave this site for constructive conversation........ Mel, K6KBE

Might I ask if you have tried to isolate the source? In the tube days a gentle hiss was attributed to the electron bombardment of the plate from the cathode and was never "completely" eliminated. Whil

Hi Larry, These were made in Italy by RMI. I have used one of the HLA-300V Plus for about 4 years with my KX3 and the FT817 before with ZERO problems. http://pa0fri.home.xs4all.nl/Lineairs/HLA300/hla3

Thanks Joe, found the peak hold. Still on my P3 the blue modulation line is a slow arc but unless you are looking at the really low audio tones, -500 Hz, which are about -12 dB, the rest of the audio

OK, as stated, I ran the peak hold which actually the average with a setting of 20. No difference, sorry. You have to perform the test to see it your self. No more on this thread unless P3 tech suppor

Yes, Joe, But the difference is the display is the question. WHY? My 8920 show proper power distribution on the sidebands, the P 3does not!!!!!!! Mel, K6KBE

Added note. In my lab, I set up the following: Advert 7200A signal generator and HP 8920A analyzer. All tests prove that a AM 100 % modulation carrier the sidebands are ALWAYS 6 dB down from the carri

OK, Alan, Thanks for the input. Here goes. I am monitoring a friend near by, 15 miles. I took care to have him set up the 100 W SSB station and his 1KW AM station like this. In CW mode, send a 100 W m

Yes, Alan, I understand all of that. Here is the question. Why is the sideband power on AM on the same band, 75 M, less than the displayed signal on SSB. An example. Watching the 100 watt signal on 39

Final comment after some bench testing. I put the signal generator with 1 KHz tone at 100% modulation into the 8920. Sidebands were 6 dB down. I then put the signal generator on 7.2 MHz at +20 dBm int

One other thing Grant is that when a BC station transmits a single tone, the sidebands at averaging or open should be 6 dB down. It never is? As a side note, my HP 8920 shows a proper power distributi

Tried that, still the sideband sweet spot, Most power is still down considerably?? Not so with the SSB. That is the CW level of peak carrier and the SSB are about right. Just confusing. Mel, K6KBE

I have noticed a difference in the modulation sidebands on the P3 of RF waveforms on SSB and on AM. On SSB either L or U the modulation display on the P3 is very close to the 6 dB down from where the

I also use the Audio Technica MB 3K with very good results on a boom. Mel, K6KBE

Easy, set up the start frequency in memory and the other in memory and toggle...... Mel, K6KBE