Then logging couldn’t happen in the HRD logbook, it gathers data from the rig app needed for the entry. Importing from WSJT- X log would have to be done (unless separate logs are wanted). It would als

I do not, but suggest 'Fake it' is better in some cases. Testing should be done, 'Fake it' is simpler. I use the HRD interface (set the radio to HRD in WSJT-X), which forwards commands to the radio (v

Jim, If you have 'Fake It' on (and you SHOULD); if the tones selected are not between 1500-2000 Hz, the radio will shift the VFO frequency so that the third harmonic of the audio will not be transmitt

And some, like me, test the UI being useful without a manual as one of the tests to system quality. Settings most used, easily accessed, wins. (This defines the Elecraft model.) Having to go layers de

Mike, I have not done this; but use a special Y cable on my K3 so the SteppIR controller can copy the frequency of the radio (which is connected to a computer). So it should be possible. (The SteppIR

In that case, check to see if you can 'share' the serial output of the Arduino to both the amp and the K3S ("talk" to both at the same time). As long as the command sets are different (i.e. K3S comman

From the programming manual: PS (Transceiver Power Status; GET/SET) SET/RSP format: PSn; where n = 1 indicates transceiver on. Note: PS0 turns the transceiver off, but this removes power, so PS1 canno

I would submit that if this was required; the station isn't assembled correctly. While a few interface cables (USB, unfiltered audio) may need added ferrites (a flaw in the computer, not the radio), i

Thanks for the reminder; now joined. Rick NK7I

You've forgotten the update mentioning the shake down of the new linux OS and firmware changes already? It spawned another lengthy discussion as well. 73, Rick NK7I

Not everyone voted in that fashion. But as I was not in the majority (for the last 30 something years), I escaped. However my comments were not about politics as much as they were about the current co

Apparently not everyone is aware of the rapid changes being made by the regime in CA. Close everything, essential only (where the %&#^ is THAT stated in any laws), partially open, slam the doors shut

Have you played with the VOX settings then? Gain, level, antivox... and turned VOX on? ;-) 73, Rick NK7I

Bob, Cable management is a fallicy; it'll always be messy looking but one can try. Most hams don't have the space (or will power or interest or ability) to keep everything neat and tidy. I'm still bui

Hi Bob, If you have the new i/o and audio card in a K3, or have the K3S, then yes, you can do audio and CAT in one USB cable. In that case, someone else will have to walk you through the how-to, I don

Oops. You’re right; I got in a rush. The P3 gets freq data and filter config on the RS232 cable to display both. Rick NK7I Email spiel Czech corruptions happen

To what point? The PC->P3->K3 serial port by itself works, both ways. The PC (which runs the WSJT-X program) can either use the serial port stand alone or via other software (HRD, N1MM+ etc) for CAT.

Did you switch antennas, RX or other? Rick NK7I

Because improvements occurred, normal to any new product. Rick NK7I

No, the limit is much higher. I had to send my (very early) KPA1500 back for some hardware updates, the shipping wasn't bad considering the weight (RF deck only) but the cost of the $6000 insurance wa