Asking the obvious, did you power the radio off, remove power cord for 30 seconds and then bring it back on line? Some components, USB in particular, don't clear properly all the time and need a prope

You might also look at the J pole designs if you're looking at verticals. Some gain, easy to build but you have to know how to solder copper pipe and deal with the price of copper. Don't use 1/2 inch,

I erred in a previous email to the list, my LIN OUT is set at 2. Rick nhc

You're quite welcome Harry. I'm glad that you found the issue and that you're up and running. Rick nhc

LIN OUT is stereo, so you'll use a TRS connector (tip, ring, sleeve). MIC in is (almost always) mono, so you'll use either R or T when making the adapter (plus S). (choose the wrong one with no second

LINE input is stereo, MIC input is not. Rick NHC

Pilar Rick WA6NHC Tiny iPhone keypad, spell check happens

In many states (CA being one), it is illegal to drive with both ears covered (ear buds too; yet if you're deaf...). So a pair of speakers mounted on the head rest may allow close audio and still be le

So it's within the realm of possibilities that a device similar to the K-pod could be made using the RJ-45, with a sound card added, for full network access?� That would simplify remote ops or allow

I may have missed this as I wasn't following the thread, sorry if it is a duplicate answer. Should be FOUR bars lit, the fifth flickering. THAT is the zero ALC on the K3 line radios. To do less invite

Not inherently. You could do that in a macro on the PF or Mx buttons to change mode and power... but honestly, you don't have to reduce power for the digital modes unless you want to (use only what yo

With (John?) wearing the logo'd tee shirt, of course... ;-) I'm sure glad we BOTH had K3's on 160 the other night... JUST as the QSB hit a valley but we pulled it out! (They're back there now, even lo

Unplug all but power and see what happens.� In particular, the mic. Rick nhc

Did you change the metering to show ALC? I know, DOH! Upper right button, left bank press and hold. Rick nhc

Data-A is just fine for most folks that switch data modes often. You lose the Dual PB, but that is rarely needed. HNY, Rick nhc

The answer there is to take the USB-Serial device and plug it into EACH USB port on your computer and (via Device Manager) TELL the OS what port you want it to be in each case (the same). Do this with

Further, when you are VERY close to matching the pitch of the beat note, you will hear a volume change as they are momentarily in phase. This is often called wow (repeat wow wow wowowowowowowowo and y

Below are three emails that happened earlier this year on the other Elecraft list. They include a link to purchase a USB relay switch (two relays per board, independently controlled) that only costs a

The classic response is to run the power calibration routine found in the utility program. Also check the input voltage at the rear power connector while under load. Rick nhc

I use data A for all digital modes except CW. Works great except you don't get to use the APF feature. I also can widen the filters (~3K) to view multiple QSOs at the same time, then by adjustment (hi