I remember all of this now. Actually I was running about 7 watts to drive the AMP after I had the PA failure at 100 watts, there were no issues at 7 watts. I was trying to make the point that I was

Running 12 watts on data modes is bad. The low power PA won't withstand that. -de John NI0K Jeffrey griffin wrote on 5/3/2020 12:35 PM:

Agreed hence the ridiculously low bids

I thought “auctions” were not allowed on this site (???) Chas

I see a trend here and it gonna get ugly!

My bid 52$

Last summer I was running more data modes (FT8) when I started having an issue with the 100 watt PA failing with a ERR 12V message. I then did the KP3A power connector replacement. This worked fine

my bid: $51 :-)))))) 73, Martin, OK1RR Dne 03. 05. 20 v 17:05 dean laclair napsal(a):

I was questioning whether the K3 was seeing the KIO3B and not selecting the Line IN but that's probably not the case. 73, ... Joe, W4TV

I was guessing they are probably not accepting stuff for repair but I wanted to find out for sure. Thanks for the suggestions about WSJT-X being the root cause of the no transmit problem, I have

Yes, perhaps not right now 73 de David, M0XDF (K3 #174, P3 #108) -- I have never met a man so ignorant that I couldn't learn something from him. -Galileo Galilei, physicist and astronomer

I heard NO. But really need to hear from the Elecraft folks to be sure. Ed.. AB4IQ

But, to the original question, is Elecraft accepting its manufactured equipment for update and/or repair? Ed McCann AG6CX

Probably bring more over there. I've seen some low prices stateside for the original k3. 73 Mobile Mike 7! Absolutely Awesome

But honestly, what's your price? I'm sure folks would like an idea. The auction site is over there. Thanks, 73 Dean /K2WW

I'll start the Bidiing out at $50

I have the same issue with no transmit audio. This occurs after my screen power setting turns off my display. Upon turning the display back on, no transmit audio is sent. Once this happens, I can

You'll find that the audio won't be sent though the transmit is enabled with WSJT-X. There is a logging issue (it says it's logging but doesn't), that's happened a few times now

I have thst issue where ther wsjt and or sound card stops sending audio ( thus no rf out) .. rebooting the wsjt and or havuing to reboot comnputer has it going again. Just

Hi John, Just as a test, the next time this happens click “Tune” on WSJT-X and see if you get tones and RF out. I’ve had this happen and it’s not my K3, it’s the WSJT-X software or