Yes, specifically for things like changing power levels, bands, mixer settings, and the like. 5w, 25w, 75w and full power buttons are programmed in. That lets me get close to where I want to be

Bob, Are you using a Genovation pad? 73, and thanks, Dave (NK7Z) https://www.nk7z.net ARRL Volunteer Examiner ARRL Technical Specialist ARRL Asst. Director, NW Division, Technical Resources

The only issue on my K3S is the power setting knob feels like it skips counts. If I turn it fast it doesn't budge. Slowly turning allows me to set the power reliably. Reliably and slowly. I may

Hi Mike, I had the exact same issues with my encoders... About 5 years in... I sent the K3 into Elecraft, and had them do it, and update the radio as well, there were a few things they did to bring

I am about to start replacement of the group of 4 rotary encoders/PB switches on my K3 SN6000+ for the second time. I first replaced them in March 2015, so they lasted about 5 yrs. First time, only 2

Thank you! 73, and thanks, Dave (NK7Z) https://www.nk7z.net ARRL Volunteer Examiner ARRL Technical Specialist ARRL Asst. Director, NW Division, Technical Resources

It is actually coming along fairly nicely... I will bundle all the cables tomorrow after toning them out to make sure I made no errors in plugging them in. 73, and thanks, Dave

Dang. That is a thing of beauty… Kelly AJ6KZ

Hello, A short update on the new home for my K3. I have terminated all 80 plus BNC connectors, and the patch panel is ready to mount in the hutch... See the last 4 photos for the current state of

Thanks Keith, it is enroute and should arrive this week. It will make the W2 much more useful for me...

Don’t forget about the Higher Taxes ! WA6VAB Sent from Mail for Windows 10

You and Elon Musk.

Check the tightness of the center of the SO-239 Antenna socket. You can re-tension it with a sharp pin. Some of the older ones need it. (compare with ant 2 if you have a ATU). If you have a P3, and

Lou, Easy test. If you kick in an attentuator and the interference goes down about the same as signals, they problem is before the atten..outside the radio. If the interference drops drastically

SOLD OUT UNTIL 5/21/2020 Watch my web site www.kv5j.com

Yes, there was thread drift in the thread I started. One of the issues with groups.io is its format - it's not like a traditional forum where moderation is easier and threads are displayed under one

Did I miss something? What is this new display for the W2? N2TK, Tony

OK, if not the antenna installation... On another occasion I traced a problem like this to the connections of the KAT3  antenna tuner. Took the KAT3 out, cleaned all connectorpins of the KAT3 and

Thanks, guys, for all the suggestions. I have two antennas here, a G5RV and a vertical for 2 and 440. The problem is present no matter which antenna is inline. Both instalations are only a month old,

I also had an incident like that, a friend was getting AM stations everywhere on 80, so was I at my home, 700 feet from his home... Turns out it was a corroded guy wire... The guy was corroding at