I had a similar experience - not with a K3 but with an MFJ voice keyer which uses the same type of connector..all my attempts to tighten it enough to stabilise it failed. Once I realised it wasn't all

Must be something different from the older K3. I just checked my K3 (none S) and it is very tight... Harry K7ZOV

Well, I just checked my K3s, and be damned it is not loose too. I have never used it (I use the rear panel one), so it has been that way from the get-go. I also have a K3 (was replaced by the K3s

Mine is loose as well... 73s and thanks, Dave (NK7Z) https://www.nk7z.net Award Manger, 30MDG Grid Awards ARRL Technical Specialist ARRL Volunteer Examiner ARRL OOC for Oregon

Mike, When I sent my K3s in for service on another issue I mentioned that I thought the FP mic. connector seemed a little loose. The service report came back saying that this is normal. This has

Using the K3 Utility RF Gain Calibration works for me.

Jim, I also have a Yamaha CM-500 and it works great. Two suggestions that I have: 1. as for that "third hand", try adding a foot switch to the PTT input on the back of the K3 (search for "foot

Jim, I also have a Yamaha CM-500 and it works great. Two suggestions that I have: 1. as for that "third hand", try adding a foot switch to the PTT input on the back of the K3 (search for "foot

I noticed that the Mic connector on my K3S is loose. I removed the left side panel which gives access to the front panel board, where the connector is mounted to the circuit board. I noticed that

What are you using for a Soundcard - internal to the K3 (via upgraded USB port) or external (Navigator, PK-232sc+, etc.)? Hank K4HYJ

By chance did the update set the Line Gain to 0..... or the PWR to 0? Also check to see that the RS-232 in the CONFIG menu is set to USB. DATA A is the correct mode. 73 Bob, K4TAX K3S s/n 10163

Does anyone have a good setup document for setting up Winmor Winlink and K3? I am using macOS Mojave (I can run a Windows 10 VM), fldigi, pat, or Winlink Express (via Win10 VM). Thanks, Jon w1jp

Do you have "DATA MD" on K3 in "DATA A" position? 73 Lou KE1F

I've got a problem that just sprang up after I did the latest firmware upgrade. I've been running WSJTX to do FT8 for some time. This morning I turned it on and went to transmit and there's no power

Sold pending payment. Everett N4CY

For Sale is a LP-Pan 2 (Panadapter) & ASUS XONAR U5 Sound Card that is set up to use with a Elecraft K3/K3S. Also included are the cables for connecting everything up. The current price for the LP Pan

I would like to see a copy of the long form. 73, John N1JM

I would like to see the long form report. 73, John N1JM

If someone wants TS-890S numbers I have some on my website and more available on my long form report. Rob, NC0B rob@...

A comparison with TS-890S would be interesting ! 73, Roger DL2YDP