Thanks, When I push the DISP function and scroll through the settings I get the following setting: Time and Date - both are correct 0.00 - Not sure what this is measuring 13.4 Volts 1.33

I want to thank all who have made recommendations, I really appreciate the varied sources for the toriods. I have ended up buying a "10 pack" from Pro Audio Engineering. I was pleased with the price

I got that once and that was the PSU running low volt. Check that for a start. I am not sure whatever there is a replace bar battery in a K3. 73, Joe OZ0J Fra: Elecraft-K3@groups.io

I received a low battery prompt on my K3S. It flashed on for few seconds and then disappeared. In K3_EZ software I get a reading of 1N in the BAT MIN under General Config. I am not sure this is an

The WireMan has em...... Just received 10 73, Rick W3BI

I use exclusively Tripp Lite products. (Cables/AC Isobar Distribution ). USB cables have Ferrite Chokes both ends. Power strips have 4 exclusive isolated filter banks to limit noise. There is no

Arrow does have the 2.4" OD toroid in 43-mix available, delivered, for less than $6. https://www.arrow.com/en/products/2643803802/fair-rite-products Get the Fair-Rite catalog (download off their site)

Check with Amazon. Mel, K6KBE

Mouser is and has been my choice with stock...... Mel, K6KBE

Arrow has had no stock for months now... I started to order from Mouser, and I think they also showed no stock, once I got to the page to pay for things... If it turns out they have stock, please

Problem with Arrow is they show no stock.

Mouser Ed.. AB4IQ

Guys, Thanks for all the suggestions, I have my home work to do tonight! 73 de Jim - KE8G

I would second the suggestion to use mix31... I think Mouser is out of stock, as are most folks that sell for any reasonable price. Mouser, was selling for five or six bucks each. 73s and

I buy mine from Mouser Dale, k9vuj

Mouser Dale j

Buy them direct from a distributor like Arrow and avoid the retail markups. Use Mix 31. You can use snap on beads for USB cables if large torioids are not convenient but always use at least a few

Try https://www.kitsandparts.com/ You might want to try both FT240-43 and FT 240-31 cores. I wind 17 turns of RG 400 coax on them. I have one at the antenna feed, one before coax enters my house and

Hi All, Well, after experiencing the RFI problem, first time by the way, I am looking to buy some toroids to keep it from happening again. Anyone have a good supplier for these? Thanks in advance, 73

Computer time accuracy is VERY important when using FT-8 I use Dimension 4 which is free software to make sure my computer clock is accurate. If you are decoding a few signals, note the DT