Mouser is and has been my choice with stock...... Mel, K6KBE

Arrow has had no stock for months now... I started to order from Mouser, and I think they also showed no stock, once I got to the page to pay for things... If it turns out they have stock, please

Problem with Arrow is they show no stock.

Mouser Ed.. AB4IQ

Guys, Thanks for all the suggestions, I have my home work to do tonight! 73 de Jim - KE8G

I would second the suggestion to use mix31... I think Mouser is out of stock, as are most folks that sell for any reasonable price. Mouser, was selling for five or six bucks each. 73s and

I buy mine from Mouser Dale, k9vuj

Mouser Dale j

Buy them direct from a distributor like Arrow and avoid the retail markups. Use Mix 31. You can use snap on beads for USB cables if large torioids are not convenient but always use at least a few

Try https://www.kitsandparts.com/ You might want to try both FT240-43 and FT 240-31 cores. I wind 17 turns of RG 400 coax on them. I have one at the antenna feed, one before coax enters my house and

Hi All, Well, after experiencing the RFI problem, first time by the way, I am looking to buy some toroids to keep it from happening again. Anyone have a good supplier for these? Thanks in advance, 73

Computer time accuracy is VERY important when using FT-8 I use Dimension 4 which is free software to make sure my computer clock is accurate. If you are decoding a few signals, note the DT

Larry, I run my K3s in data mode for FT8. Make sure you run width 2.7 to 3.0 khz bandwith on recieve. I usually adjust WSJT-X to start recieving above 350hz, as transmit filters cut off signal below

Lol my buddy woke up and realized what he had was better than what he was looking at! Thanks for the offer, i still have and intend to keep my 2 K3. 73 de Bill WW5M

Hi, Bill. Sounds like a nice rig. As you would expect, the prices vary, depending on a number of factors. Send me an email and I'll get some particulars sent your way. /Mark w2or (at) arrl (n e

Check, then re-check your time sync. Even a second or two off, and you will not decode signals even though you can transmit (out of sync as well...)

A little further down this trail... If you use DATA A mode (and you should) for FT8, you also negate any settings of audio shaping they would typically be used on SSB (both RX and

Hi, I tried this on my souped up K3. To my surprise the virtual COM port shows up in the device manager even when the K3 is OFF (even with DC power supply off as well!). In both cases the utility will

I operate FT8 using DATA A mode. When I am decoding FT8 I find I have the best results when the WSJT-X input graph to the left reads between 60dB and 70dB. Mouse over this graph and it recommends

On my K3 i set the bandwidth full open because a lot os activity appears from 200 cycles thru 2.8 kc audio wise. If it's set to narrol you will not (possibly) hear or decode all of what's