Nate, It took me a while to get to try your suggestions, but they worked perfectly. Thanks. 73, Mark

Some time ago I noticed that my K3/0 created two USB ports (/dev/cu.usbserial-00001114A and /dev/cu.usbserial-00001114B) once it is connected to my Mac. Communication (K3 utilities, RHR Helper, ...)

I have been running Linux Mint for some time. I would contact the original writer of the program you installed. The purpose of the files will determine if you only have to name the file or copy the

* On 2019 25 Mar 17:33 -0500, Mark Erbaugh wrote: As already mentioned, "multiarch" needs to be enabled so that "i386" packages may be installed. I have documented the steps

I just hit this issue with libgtk-x11 a couple days ago. You have to install the i386 (32 bit) version of the library. I don't know what tool mint uses, be it apt or yum or what, but on debian I

I recently connected my K3 line to a computer running 64-bit Linux Mint 19. I downloaded the K3, P3, KAT500 and KPA500 utilities. The K3 and KAT500 utilities run fine. The P3 utility reports a

13.4 VDC is low. Can you tweak it up to 14 VDC? Avoid sources of loss in the lead by removing any in-line fuses. Check all the connections. The indicator has nothing to do with the coin cell which

I had this with my K3. I found that I had somehow moved the voltage control on the power supply. Resetting to 13.8v the warning went away. Look in this area before anything else. Stuart, GD0OUD.

KF7P has some nice stuff. Ferrite choke kits for coax, USB, and ethernet Ferrite choke kits for coax, USB, and ethernet

Nothing if you order from Digikey and pay with a check. Free shipping and handling. Check their terms of service. -Bob N3XKB

What did they nick you for shipping 10 of them? 73s and thanks, Dave (NK7Z) https://www.nk7z.net ARRL Technical Specialist ARRL Volunteer Examiner ARRL OOC for Oregon

Hi all, I have used Mouser for all my ferrite choke needs for a very long time. I always use mix #31 and have never experienced them out of stock. I also buy my Amphenol coax connectors and adapters

Thanks, When I push the DISP function and scroll through the settings I get the following setting: Time and Date - both are correct 0.00 - Not sure what this is measuring 13.4 Volts 1.33

I want to thank all who have made recommendations, I really appreciate the varied sources for the toriods. I have ended up buying a "10 pack" from Pro Audio Engineering. I was pleased with the price

I got that once and that was the PSU running low volt. Check that for a start. I am not sure whatever there is a replace bar battery in a K3. 73, Joe OZ0J Fra: Elecraft-K3@groups.io

I received a low battery prompt on my K3S. It flashed on for few seconds and then disappeared. In K3_EZ software I get a reading of 1N in the BAT MIN under General Config. I am not sure this is an

The WireMan has em...... Just received 10 73, Rick W3BI

I use exclusively Tripp Lite products. (Cables/AC Isobar Distribution ). USB cables have Ferrite Chokes both ends. Power strips have 4 exclusive isolated filter banks to limit noise. There is no

Arrow does have the 2.4" OD toroid in 43-mix available, delivered, for less than $6. https://www.arrow.com/en/products/2643803802/fair-rite-products Get the Fair-Rite catalog (download off their site)

Check with Amazon. Mel, K6KBE