Yeah, Those were the days... 73 Arie PA3A Op 26-8-2022 om 07:25 schreef Jim Brown:

And it's my understanding that Elecraft QCed them for low IMD. 73, Jim K9YC

In case someone wanders, inrad made the 8 pole filters at least in the early days. 73 Mike R 7! Absolutely Awesome

I have extra filters I ended up not using in my K3/S so they are for sale: 2x 7-pole 200Hz Elecraft KFL3A-200 filters, the offsets appear to be matched: asking $75 each, shipped. 7-pole Elecraft

I'd never checked mine until now. In doing so, I find both the front and rear PHONES locations to have the same level for the receiver and sidetone. No issue here. I trust one is using the same

The Elecraft Xverters have been sold. Thanks for all the inquiries. 73 de Fred, W1SKU

Hi Dean, Sorry, but the 3 Xverters have been spoken for. 73 de Fred, W1SKU

Fred Thanks for the email. My client puts replies in my sent box, and often don't automatically see them. Can you send me a few pics to either here or my cell 315-705-1311? Whichever is easier for

Hey Everyone, A bit off topic, but l listened to a short, but great segment on ham radio the other morning on NPR: The eight-year-old daughter of M0LM worked the ISS on a pass. I don’t know if

A friend is using the K3 and has a problem. The front panel phones jack is working properly - both in sidetone and radio volumes. But the sidetone volume in the rear phones jack is low, and the radio

For PTT-KEY from N1MM I set PTT=OFF, KEY =DTR, but VOX has to be on to get power out. Otherwise it keys with no power. Convenient when I want to take a break, I just turn VOX off to avoid spurious

I noticed Saturday prior to SSB NAQP that setting my K3S and N1MM for PTT via USB RTS resulted in N1MM not being able to assert PTT so I went to the N1MM software command option for PTT. This morning

The purchaser backed out, so the transverters are available. All 3 for $500 plus $50 shipping. 73 de Fred, W1SKU

K3S & P3 for sale now SOLD. Thank you all for the interest shown.-- 73 de Steve GM4OSS K4D #775

I sorry I accidentally thought it was for KX3 not K3-- Anthony Luscre K8ZT Ohio Section Section Youth Coordinator & Education Outreach ARRL - The National Association For Amateur Radio™ k8zt@...

Nice article by AE9K... http://www.ae9k.com/home/elecraft-k-line/transport

Not as robust, but still provides protection and is ready to operate without removing from the case- KX3 Rapid Deploy Go-Box- tiny.cc/rapidkx3 KX3 Documentation Instructions Go-Box -- Anthony

In addition to Pelican, have a look at Plaber, https://www.hprc.it They "are a lot like Pelican" but use a resin material that is as robust but not as heavy as Pelican and also not as expensive. When

Hi Chuck, I use a Pelican 1600 in desert tan for my K3/P3 and it holds them both with two rows between and 3 or 4 rows around the combo. It's FB for me, not the place to save a few bucks IMO. --

Yes - that was the bypass VSWR. The matched VSWR is around 1.15:1. My 80M antenna is just a dipole that is cut a bit too long and is fed by a 1:1 balun & 50 Ohm Coax. When I get a chance, I will