Hi Burt, I'm not the moderator on this list and while it's true the moderator might have misspelled your name, maybe.....it's also true you can quite easily fix this yourself by logging into

Jim - I figured it would be an impressive assortment of 160m antennas, and you don't disappoint. With all that going for you, there must be something else holding back 160 at your location (terrain?

Hi Len, I have three for TX. The first, a Tee with the top supported to about 100 ft between two redwoods, with about 60 on-ground radials; the other two are wires sloping to the east and to the west

Sweet! I wish I had room. I would suspect you feed more than one band? Bill K9YEQ

Jim - What are you using for an antenna on 160? 73 Lyn, W0LEN

Search the manual for EE INIT. Before anything, it's best to use the K3 Utility program and save your current configuration. After that make sure you have the latest firmware

Hi Moderator, Thanks for inviting me to the group. My name is wrong as submitted by KCARC: My last name is Boyd, not Byod I have a question and hope there is a solution for convenience:

Hi Russ, For some unknown reason, my installation of the KAT500 Utility requires that I ‘Run as Administrator’ to have it function properly. Something is amiss in the labyrinthtine Windows

I have a non-technical question. I use the KPA500 / KAT500 combo with an IC 7300 transceiver. When I went into the KAT500 Utility Program to check firmware date and look at my configuration settings

Looking for a KRX3A sub receiver for my K3S. With or without filters is OK. Would also consider a radio that has the sub receiver installed. If a K3, it would need to have the upgraded KSYN3A

I bought a pair of those King products and they seem to work just fine. Thanks for the tip. Larry W0OGH On 2/1/2021 11:59 AM, Paul McKee wrote:

-------- Forwarded Message -------- Subject: Re: [Elecraft-K3] K3 power adjustment Date: Sat, 24

Bob, I'm just getting setup for FT8 with my K3s. The explanation W3FPR gives is really clear and understandable. Thanks for the tip. 73, Chuck K0MV

Bob, I'm just getting setup for FT8 with my K3s. The explanation W3FPR gives is really clear and understandable. Thanks for the tip. 73, Chuck K0MV

In this case, a PITA. But there is a lot of misinformation Elecraft manuals DO give VERY specific instructions for DATA modes. DATA A mode transmits USB from a computer fed to the Line Input, with

Wes, That is a gross misrepresentation of what Rick said, but even though it is misrepresented, it can serve to make my point... Here is an example-- Using the radio as you describe, will, not

Of course, I was being facetious. But there is a lot of misinformation and confusion in this thread. I'm not sure any Elecraft manual gives specific instructions, but this link to my friend Lyle's

Wes, Elecraft has given specific instructions about audio drive levels in their products, which are not the same as other brands. And they explained exactly why. They do

So you're telling me that if I have the power control set to 100 W and I put the radio into transmit on SSB, but I don't speak into the microphone, the radio is going to generate 100 W of noise? Wes

The advice to read the manual is important Sandor. The K3 power control is very different than most other radios. An important aspect of K3 power control and TX audio level that impacts other users