Hi Keith V 05.67. It seems to be the latest according to your homepage. Joe, OZ0J Fra: Elecraft-K3@groups.io <Elecraft-K3@groups.io> På vegne af Keith_WE6R Sendt: 12. oktober 2020

Hi Joe, what DVR Firmware do you have? Turn on radio, config menu "FW REVS", rotate VFO A all the way clockwise. Keith WE6R Elecraft K3 Tech

I once had the same problem. UK support suggested checking proper seating of all Inter-board connectors. Until my next serious contest with it I’m not sure if it is fixed yet. Keep you posted. 73,

Hi I have an Elecraft K3S with the KVDR3 installed. I used it a lot during the SAC SSB Contest this weekend. When running the DVR in repeat the DVR decided to send empty CQ (TX on but no

Thanks Bob I tried it and surprisingly if I touch the power knob the power display jumps up to the 7 watts TUN PWR setting, but then immediately drops back down to 0.0. From the manual: TUNE Power

I'm putting my K3 (Serial# 6384) up for sale. Do not reply to the list, I will only reply to direct emails if you convince me you are serious and then we set up time to talk on the phone (any cc'd

After you press TUNE and the TX LED is on, then adjust the PWR knob to your desired power value to tune. 73 Bob, K4TAX

Bill It's not a tuner issue. On "tune" my K3 reports 7 watts out on all bands except 30 m, where it reports 0.0 watts out. The power meter confirms no output. -- 73 Bob KD8CGH

Hello, A update from my site. After some more test last week I got completely confused. Sometimes it worked, than it stopped. I completely removed the software from my laptop: mmtty, n1mm, microham,

You don’t mention what tuner you are using. I use a remote tuner and find a similar situation, MFJ998 in a patio box. When it doesn’t tune, I remove power for seconds plug back in and then tuner

I have a remote tuner so I hold the "tune" button to send a low power carrier for the tuner to operate. The tune power is set by the config parameter TUN PWR. This works great for every band but 30 m,

Figured it out - Data Mode was set incorrectly on 10MHz! Chris Cox, N0UK chrisc@...

Thanks Jerry for your advice, I decided to go first class and ordered a shipping box ($50.00 include shipping) and put the transformer back into the unit without reconnecting it. I am

Hello Joe (W4TV), I did the simulation of the AF filter (p. 35). Please find the result attached. 73, Robert

Lou, Check with Elecraft first and ask for a support person first before shipping the transformer. They will tell you if they need it in order to repair your unit. Most cases they do not.

I wish when I was issued a Return Authorization number, availability of shipping box information should be attached for the model in question. Too late for me. I am going to FedExp to

https://elecraft.com/pages/shipping-box-sets-item-return-for-servicing Here's a link to the order page, for different boxes.

I offered to pay for shipping cost between Cal and Fl for the box they will use to return my repaired KPA500 amplifier. I haven't received a reply. COVID or the Forrest fires may be responsible for

They sell the shipping boxes Chuck Jack Hawley KE9UW Sent from my iPhone, cjack

I asked customer support but never received a reply. Lou KE1F Sent from my Galaxy Tab® A