That was exactly the fix, Mike...per N1MM support...logger doesn't know "length" of message...so add 5 sec to recorded length of message...works fine now... 73, Neil AE1P

I had a similar issue when wishing to power up the K3 at the remote station every time the 12V power supply was switched on. My solution was an 8 pin PIC, see

Hi Guys. Not had these issue with my line up, however had issues with flashing software. (K3 Bricked) As Engineer having updated software "all my life" and having experience over here with the K3 -

Friend of mine in Eastern Oregon Mountains was experiencing what seemed similar. Tried all sorts of normal trouble-shooting steps with no resolution. He was running WSJTx and monitoring WSPR. When

Thanks Joe. The thought that the PTT response is a red herring had occurred to me. That's one reason why I am not 100% sure whether its the K3s or the P3. You are correct that I do not have the TXMON

Mine is different, flashing in cold weather, nothing on K3 changes it. So thinking electolytics P3

PTT is a red herring ... The display update is suspended in transmit unless you have the TXMON option installed (which does not appear to be the case). 73, ... Joe, W4TV

In my case bothe the P3 & external monitor flicker until it settles down and works properly. Lou KE1F Sent from my Galaxy Tab® A

Hi Alan, No, I have not tried that. Maybe this evening after work I'll give that a try. Thanks for the suggestion. I'm pretty sure the issue is in the K3s, probably on the KIO3B, but I am not quite

Hi Chuck, Have you tried doing a Parameter Initialization? (Described in the Troubleshooting section of the P3 manual.) Alan N1AL

Here is a link to a video I shot showing the issue. Hopefully it is accessible from here. https://photos.app.goo.gl/32VjRyny1gJmfx1Y8 Chuck Wpbik

Hi Gerard, Maybe try swapping the two P3's and see if the symptoms stay with the old setup? If so, it would confirm the issue lies within the K3s. Chuck W9BIK

I’m not able to get anything on my monitor from the P3. When I plug in either the Elcraft or replacement 15 pin cable, between the ACC on the K3 and the RS232 port on the P3, The K3 freezes while

It does not effect the external display. And now I got a second newer K3S and other P3 for SO2R. It has not happened yet on that setup. Electolytics I'd say......some only have 1500hrs life. I've

I am having exactly the same issue. Lou KE1F Sent from my Galaxy Tab® A

Yeah, have this happening the last few years....especially in winter. Think it might be capacitors. Gerard EI5KF

Hello fellow K3'ers... Last night my P3 display started intermittently flashing on/off rapidly. The entire display would rapidly flash on/off, including the border lines, function key menu,

You need to set the repeat interval (Ctrl-R in N1MM) to a length that is longer than your message. 7 to 9 seconds seems about right for most CQ messages but you may have to set it longer if you talk

I'm using the published macros to key the M1-M4 bottons with N1MM and built in DVR... I'm not having any difficulty getting the K3s to CQ with M1 , but with N1MM in "repeat"..its not dropping

Switch on the ALC meter on the K3, Set processor to zero, Speak in the mic Set mic gain to a point where ALC flickers between 5 and 7 blocks on the meter. 73 Arie