I sold my W2 and sensors when I learned of the functionality of the PTX. The W2 seemed a redundant box (in my situation) given the PTX, plus my existing KPA/KAT500 components. Dennis, K7FL

The KAT3 is currently switched to the values for matching to a 50 Ohm load to "switch it out". The "Tuner" section of TLW shows less than 0.1 dB "loss" for either a high- or low-pass L network at 50

I have the W2 and two sensors, the 200 and the 2K hf ones. I'm thinking that I will sell the W2 and keep one of the sensors...probably the 200. I really need to know how to "broadband" the sensor and

K3S FAQ: Lower loss on bands where matched antennas are used. I am curious about this. Can anyone explain how much difference and how the KAT3 is switched out presently. If the KAT3 is shown in

Thank you, Bruce.... I did see that but thought it was associated with CW keying. Roger G0IUW

Training is the key here I'm afraid. The first year I brought my K3 to FD I made a quick guide that explained a few things like this Made sure to stress "TAP" vs. "PRESS&HOLD". Also discussed

Hi all, If you're at Dayton, please stop by the kit forum at 11:45 this morning in room 5. Joe (K0NEB) always does a great job, and there will be a couple of other presenters. I'll show a K3S and

Run down is an understatement on the facilities.. (It is in competition with municipally owned convention centers and assorted other facilities in the area.. It started life as a ice rink for a pro

Heh.. Last year there were a few food items that were freshly made (pizza being one of them... and were fairly tastey. Perhaps not really GOOD for you, but then most folk would put a mile on their

I don't believe this is possible with the current firmware - it would require some amount of change and would probably be best achieved with a config option to allow you to disable any function,

Not quite sure what you are "just sayin'" by that "human" remark, but you seem to be suggesting that Elecraft enters into the second-hand dealer space, maybe selling reconditioned K3s (K3's?) with

Maybe Elecraft could provide/specify a "K3 Trade-in" option. 'Twould make upgrading to a K3s much simpler, if Elecraft could do so without taking a significant financial hit. Also it would seem to

I would be VERY interested in learning how to do this for the same reason. 73, Jim VE7FO

Dayton, "a must do" experience for all Hams, not unlike a (dare I say it in today's PC climate) a Muslim's mandated pilgrimage to Mecca. Went to the Dayton2013 event and really had a marvelous

Your friend is almost 100% correct. He misses the mark on "low end truck stop food". It would require considerable improvement to reach that status. 73, Bob K2TK

Next week we'll add this info to the FAQ. Short answer: yes, you could move your KAT3 and KRX3 to a K3S. 73, Wayne N5KR ----http://www.elecraft.com

Just ordered a fairly loaded K3S. I'm personally thrilled to have the new USB port on the back. It makes it much easier to concurrently connect peripherals such as amplifiers and computers. In

ACC connector, pin 10, KEYOUT-LP. See page 18 of the operators manual. Bruce N1RX

>>> The box is not much big, <<< The DOG House is also "not too much big" I feel your Pain! BTW! If you need to blame on on someone. Blame it on Wayne! ;-) ((((73)))) Milverton / W9MMS.

Jack, Thats a very good question ! Bob K6UJ