Re: 100 watt PA issue
toggle quoted messageShow quoted text
And the IMD will be awful.
On Sunday, May 3, 2020, 2:59:43 PM MST, john ni0k <jasimmons@...> wrote:
Running 12 watts on data modes is bad. The low power PA won't withstand that.
-de John NI0K
Jeffrey griffin wrote on 5/3/2020 12:35 PM:
Last summer I was running more data modes (FT8) when I started having an issue with the 100 watt PA failing with a ERR 12V message. I then did the KP3A power connector replacement. This worked fine for a few months. It was working fine till I once again noticed a strong burnt electronics smell coming from the K3's PA. I at that time just used it at 12 watts to Drive the KPA500 for a while as this worked fine. Today I decided to take it apart and try to determine what the issue is. After removing the KP3A module I noticed that L23 on the main board is severely heat damaged. I wasn't expecting this, I was looking to inspect the power connector that I had fixed with the gold pins 6 months ago. Anyone have any thoughts on why L23 would fail? Before I send it to Elecraft. Thanks... 73 Jeff kb2m