Re: KPA500 Input power vs. output power

Rob Sherwood
 

Hi Dave,

Ok, thanks for your quick reply and the spreadsheet link.

Rob, NC0B

On Feb 7, 2020, at 10:15 AM, Dave Cole <dave@...> wrote:

Hi Rob,

I would be surprised if the raw date were granular enough to show the 1 db points...

This was a rough graph designed only to help new folks get a feel for the amp. I just put a link on the web page to the spread sheet in the text...

As you can see, it is a very rough dataset, not designed to show 1 db compression points.

73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist
ARRL Asst. Director, NW Division, Technical Resources

On 2/7/20 8:32 AM, Rob Sherwood wrote:
I would like to know the 1 dB compression point of both Elecraft amps, and others too, for that matter. Here is the general issue that I first ran into in respect to the Beko 2 meter amp. It was a Flex 6700 version that could be driven to 1 KW output with less than +10 dbm. This made it very easy to test for IMD.
The spec on the Beko is odd as it is rated at 1000 watts PEP on SSB, but the 1 dB compression point is specified at 1050 watts! The amp is quite clean at 400 watts PEP, acceptable at 500 watts PEP, and from my perspective unacceptable at 600 watts PEP.
I don’t know if the graphical data just shared is granular enough to extrapolate to the 1 dB compression point. I wonder if the raw spreadsheet data could be made available?
Rob
NC0B
On Feb 7, 2020, at 6:34 AM, Dave Cole <dave@...> wrote:
Wish I had a KPA1500... :)

73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist
ARRL Asst. Director, NW Division, Technical Resources

On 2/7/20 5:01 AM, John Canfield wrote:
Very interesting Dave, good job. I think your ratio of input power to output power would correlate nicely to my KPA1500.
John WB5THT


Join Elecraft-K3@groups.io to automatically receive all group messages.