I use a Wellbrook loop and a LZ1AQ Loop (best one) and a Cross Country Wireless Loop Also a 80 Meter delta Loop ....I have used all the Made in China Loops they work fine in my opinion but there not f

http://sdr.eladit.com/FDM-sw2%20Software/Under%20test/index.php?lang=EN

I have used a few time lately but in my opinion its not so good one min works fine turn off radio next day turn on dose not work i just stooped using it .....

Dose this work on others radios on mine all the audio is distorted no matter were the slide control sits .

I tried the update from the 25 June works a lot better than the first one going to try it out for awhile

Well it is a beta program my problem was it was not reading the frequency correctly it was as if it was running split i shut the program down and went back to FDM-SW2 and it was then transmitting on a

Wow is right i removed it as fast as i installed it after i started reading the setup instructions

I was unaware i had submitted a fault report . It appears you have had your own problems with it .........

The fault is............. no audio Is it reproducible,,,,,,,,,,,, yes What firmware/software versions and operating system?/........ The latest The whole advanced panel is buggy i have read about it o

And many more on other forum

Using mic plug into elad

I have never been able to use any thing in the Advanced setting If i try to turn it on i loose all my audio and have to reset ever thing to get radio to work properly again ..I had a look around the n

Start button is lower left corner..

That is part of the same problem other have had for a long time i am using there FDM-S1 receiver NB and notch are both unusable been like that for over a year that i have owned this receiver so i woul

That works great thank you very much

I am well aware auto notch does not work in FDM SW2 but does manual notch work i have read people saying it works but i can't make it so ..........

Just my opinion i would have like it the normal way or the way all my Ham radios are or at lest the ones i have owned i have no overly strong signals here on the island so the attn is of no uses here

Well as for the attenuator It is nothing like any i have used before with my hf radios the attn i use i can see and hear a steady drop in back ground noises as with my orion i have three setting 6db,1

Well i used my sark 110 and put 50 microvolts or -73dBm into my sdr FDM-S1 .The FDM -SW2 software reads S7 my Ten Tec Orion reads S9.. The attenuator in the FDM-S1 does not change the meter reading an

Wow great reply thank you ..At this point i have only compared the meter reading to my other receivers they are all close.. Typically my other will read s9+15 db and the and the FDM-SW2 reads s9 it is