Is the pre-amp engaged – upper right corner checkbox.

In SW2 there is a new option, I think on the Recording Tab, to set (Windows) Highest Priority, have you tried that? I would also buy an SSD (the one I suggested with the cable) and try that. It might

Ivan; While I don’t think this is the problem, the numbers from your D Drive look terrible. Your screen shot shows Sequential Writes of >420MB/sec and Sequential Reads of 37MB/sec. I’ve never seen a S

Sorry that’s 3.49. It’s in the “under test” folder. Bill

Maybe upgrade to 3.049? Bill

I’ve seen the waterfall on SW2 freeze, turning into a smear and audio stops. That seems to be the most common crash I’ve seen over 5+ years of using SW2. But for the GUI to close completely I can’t sa

Never seen that one. Maybe virus scan software/Windows Defender doing an hourly scan? Bill

I’m curious, why do people need an ExtIO DLL? SDR-Console works today with S3 - https://www.sdr-radio.com/elad Bill

Hi Mike, try the "LOCK TO CF" button at the top, just to the right of the frequency. When enabled (white button) the band (LO/CF) will move as you tune. When disabled the band (LO/CF) will stay locked

#eladsw2

Chris; Forgive me as this is a very basic reply as it is 6:15PM and I really want to step away from this %$#@ computer so I’ll make this brief. You could download some of the sample files - http://ela

#fmd-s3

It’s more money but have you looked at the TMATE? https://shop.elad-usa.com/tmate/elad-tm2-usb-tuning-system-tmate/ Bill

Mike, thank you for sharing that. I think your good results are because the 8TB drive is internal and SATA connected. I typically use external USB3 8TB drives for an offload for internal 2TB SSD (most

Can one of you share the manufacturer and model number of the 8TB drive? Thanks, Bill

Same here. While I often run the S3 on batteries the S2 running off USB power is sometimes preferred for mobile operation! Bill

Jim, on your 1st question, on the Graphics Tab check the box for “Full BW Spectrum” near the top. Bill

Did you install the “Complete” .zip 113MiB version such as v3.037. 3_037_FDM-SW2_Complete.zip - http://eladit.com/download/sdr/FDM-sw2%20Software/Current%20release/index.php?lang=EN Or did you install

Antonio, do try a different USB port or computer if it’s a frequent problem. If it starts and runs in W7 compatibility mode that’s probably not causing it to freeze. Bill

The dreaded waterfall smear - where the waterfall freezes and the colors continue to “paint” but it’s otherwise dead? I get that on rare occasions too. But if it’s frequent that’s a problem. Your Wind

Correct. You can even run them both at the same time. Each will have it’s own preferences set and saved independently. Bill

When you downloaded and installed the software was the download 113MB or about 50MB? You must install the larger version as it contains .Net and maybe other pre-requisite software. The smaller is just