Hi all, Most impressed with the FDM-DUO on FT8 and JS8CALL, but now also looking to use with VARAC to drive Winlink express. VaRA doesn't have any settings for the Elad, is there an alternate that

Hello, I will try. Vianney Il 21/04/2022 11:41, Conrad, PA5Y ha scritto: -- Vianney Colombat ELAD Italy Le informazioni

Thanks Peter, working a treat now. I revisited the cabling to check and was plugged up correctly as you suggested, to find that the TX cable was defective. Swapping out for a spare solved the

Richard, There has been many request about WSJT-X and interfacing. Check out the Elad Download web site. Application Note AN-003 covers the set up for using the Duo with that program. As for

All, Grateful for advice. Trying to configure the FDM DUO to work on FT8, all appears well apart from the fact that my PC is not recognising the audio from the radio. The SW2 software works and

I've meanwhile found the RX/RTX input schematics as posted by Clint Chron in May 2020 in the "Photos" section. Please disregard my Message/Question. 73, Klaus, DK3QN

Good day, On page 6 of the DUO documentation there are 2 block diagrams of the DUO architecture shown: Picture 1.3.2 presents a general block diagram where the "Power and Filters Bank" is only active

Sorry I should have changed the title. Hello Vianney, I have asked Elad twice about the PN performance of the TCXO and OCXO of the FDM- S3 without a response. Can you please help with this?

Hello Vianney, I have asked Elad twice about the PN performance of the TCXO and OCXO of the FDM- S3 without a response. Can you please help with this? Many thanks Conrad Farlow From:

Yes, there is a 5V bias. Vianney Il 16/04/2022 18:30, Pete ha scritto: -- Vianney Colombat ELAD Italy Le informazioni contenute

If you have a spare (or just unused) ART 120 amplifier, I would gladly take one to add some juice to my brand new Discovery from Lab599. Thanks, Gene W3UA

The idea is to have the same structure of the S2 Ext IO DLL. See here. But the S3 is quite different and needs some extra work to achieve that. It is better if it is who writes

I can not stop the ERROR SENS PW. What can be done to correct this? The radio and DUO-ART are not used with a computer. TNX Rick

Also, with/when the FDM-S3 downconverter installed, there will be another bias voltage available on its antenna input. Pete

Looking forward to that! -- Bjarne Mjelde arcticdx.blogspot.com Remote SDR: arcticsdr.proxy.kiwisdr.com:8073/

Vianney, will this also work for SDR#? Thanks Mike

Not particularly, the worldwide situation about electronic shortage hasn't improved much since the last message, quite the contrary in fact.

It could be available by the end of May. Regards, Vianney Il 03/04/2022 22:08, Bjarne Mjelde ha scritto: Le informazioni contenute in questo messaggio di

You got it, I new it had to be a box or tag somewhere. Thanks Bob

Hi Bob, have you tried unchecking "Freeze Spectrum on TX" in audio tab in settings? Neil G4DBN https://youtube.com/MachiningandMicrowaves On 14/04/2022 10:37,