Thank you Jim. Annex A of the ELAD user manual, showing the FDM-SW2 CAT Protocol, contains a reference to the CAT commands of the Yeasu FT-897 transceiver. I found on internet (Google search) an

Hi This might not help but I thought I would mention it. I have a Yaesu FRG-100 receiver. In the Operating Manual at the back there are a few pages with the CAT commands and some code. I think the

Ok Glen, I have to make a note in pdf, it will take some time. I do not know I can attached it here at the mail list. Maybe I should mail to your personal address. Is that mail address on QRZ.COM

I'd appreciate to see the protocol and C code for that. I played around with it in early 2020 using Python. I was able to communicate with the FDM-Duo, but hadn't figured out the minimal timings nor

Dear all, Problem solved! Another day with studying the User manual and the FT-897D_Yaesu_official_CAT-Commands.pdf manual, and low-level experimenting (measuring the data-com with an digital scope,

It's been awhile since I've used my FDM-DUO. I now find that the software does not recognize the DUO. I have two cables USB connected: The CAT (near the on/off switch), and the RX on the opposite

Dear all, Does someone have experience with using the CAT from out of the SW software? I am trying to use the CAT protocol with the ELAD SW2 software. I use an FDM-S2, vs 1.3 Firmware 3.0, with SW2

I've had occasional freeze trouble with Console & RSPdx, but my S3 has been running 24/7 with Console now for weeks with no issues at all. Looks like a hw issue, but is it the SDR or the PC? --

I have a laptop USB3 connector that's a bit loose and I've seen that exact same thing on that port. Have you tried a different USB3 cable or connector? Bill From: EladSDR@groups.io

Hoping someone else in the group will have experienced what I am now experiencing with my S3 and have been able to remedy. It is starting to freeze randomly in both SDR Console and in SW2. The video

Hello, I have played a bit with the colour settings now. As I mentioned earlier, I have often two instances of SW2 running at the same time while playing back my recordings. These are typically on

I've just installed SW2 and i have the same problem number 2. with my FTDX5000 and Omnirig. I'm using FDM-S2 on RX out connector. Tomorrow I'll test on IF mode.

Hi Bill I turned all of my equipment on, planning on taking a picture of the problem. I adjusted the Filter BW and restarted my computer. Now, everything on the waterfall is exactly like it is

Can you show what it looks like with a screen shot? From: EladSDR@groups.io <EladSDR@groups.io> On Behalf Of Fletcher, Jack via groups.io Sent: Wednesday, February 2, 2022 8:00 PM To:

Is there a way to adjust or recalibrate the waterfall? When the radio and the readout at the top of the waterfall are both showing the correct frequency, the waterfall display is off by about 5 to 6

thanks all... i assumed it was some sort of filter... will have to play with it a bit...

Switching between HF and VHF inputs is obviously possible, but switching between HF1 & HF2, which I believe you are interested in, is not, I am afraid. Thiis would be a great addition. If this

Is there any way for timed and automatic, FDM-SW2 controlled switching between both antenna inputs on the S3?

Ciao Vittorio, Sorry to confirm these small glitches that some of random users are experiencing, but we all are really thankful for you to have created this really visually attractive plugin. Thank

I'm really sorry. As soon as I have time I will check what these problems are caused by. Vittorio ik4iro