Success. I was able to get the encoder replaced. It took about 2 hours, but a lot of that time was figuring out next steps. No soldering required other than removing the old encoder and soldering

Looks like the family will be moving me into a room at my daughters house. Probably in about 4-6 weeks! Anyone interested in an FDM-DUO? Latest firmware, smoke free home. (Have a TM2 as well!) I have

I looked at my Duo again. It appears that the front panel has to be removed. It is secured to the bottom panel of the radio with two screws. There is also a screw from the PA assembly attached to

I started to tear apart my Duo to replace the encoder. Unless I am missing something, this is not doing to work. I have removed a couple of boards and I now need to remove the main board – way too

Please send me a email with your asking price Jim.Allen60@... 73 KB4OVL

Looks like the family will be moving me into a room at my daughters house. Probably in about 4-6 weeks! Anyone interested in an FDM-DUO? Latest firmware, smoke free home. (Have a TM2 as well!) I have

Over the past 4 years, I have had 3 different Elad Duos. For various reasons, I sold the first two units - there was nothing wrong with them. They all had a wobbly VFO knob. Today, I received my

The UART runs at 3.3V but there are series resistors and barrier diodes, and also EMI suppression filters. Vianney Il 11/02/2021 10:32, Andy G4JNT ha scritto:

I noticed while tuning my Elad FDM-S2 across the <500 kHz spectrum this evening that an image of a signal from an AM broadcast station at 570 kHz also appeared (weaker) at 432 kHz. The difference

FDM SW2 software works fine via Parallels on my Intel iMac. However Apple have thrown a spanner in the works by introducing Macs with the new Apple M1 processor with which standard Win 10 cannot be

Paul, Thanks! Ron

My FDM-S2 went toes up after some local mains electrical problems here. So I was getting strange MW stations in the middle of 40m band and this seems to be a corrupted EEPROM. I have the unit back up

Paul, Please post pics too. Pete

Ron, I don’t have details yet, but as far as I know, take top case off just like you would to install the filters. Plug in the usb cable to correct internal slot, take out the cover for the antenna,

Paul, Along the way, it was noted that there will be three purchase options: factory-installed, Paul-installed, and self-installed. Would you please post the installation instructions so that we can

Hello Nils, very good morning. Just dropping a line to thank you for preparing the 2022-01-19 MW Offset Atlas. Brilliant idea and execution! Really appreciated it! 73, pu3hag huelbe.

Thank you Paul for the update. 73 Francesco, IN3XZP

Is the EXTIO serial input 5V tolerant ? Without thinking, I've previously connected it to my FTDI interface with 5V outputs and it worked fine, but only now realised it should have been done with

I would suggest a strong French Roquefort cheese and a glas of strong French Red Wine ;-) Klaus, DK3QN Am 11.02.2021 um 02:16 schrieb Pete:

What cheese is recommended to accomodate the impending whines?? ;>) ;>) Pete