My FDM-S2 went toes up after some local mains electrical problems here. So I was getting strange MW stations in the middle of 40m band and this seems to be a corrupted EEPROM. I have the unit back up

Paul, Please post pics too. Pete

Ron, I don’t have details yet, but as far as I know, take top case off just like you would to install the filters. Plug in the usb cable to correct internal slot, take out the cover for the antenna,

Paul, Along the way, it was noted that there will be three purchase options: factory-installed, Paul-installed, and self-installed. Would you please post the installation instructions so that we can

Hello Nils, very good morning. Just dropping a line to thank you for preparing the 2022-01-19 MW Offset Atlas. Brilliant idea and execution! Really appreciated it! 73, pu3hag huelbe.

Thank you Paul for the update. 73 Francesco, IN3XZP

Is the EXTIO serial input 5V tolerant ? Without thinking, I've previously connected it to my FTDI interface with 5V outputs and it worked fine, but only now realised it should have been done with

I would suggest a strong French Roquefort cheese and a glas of strong French Red Wine ;-) Klaus, DK3QN Am 11.02.2021 um 02:16 schrieb Pete:

What cheese is recommended to accomodate the impending whines?? ;>) ;>) Pete

Re my last post, seems I missed out on March, I posted beta in April, should have been Beta in March. Paul EladUSA

Ok this is an official update, just got off phone with Franco, he is tweaking one of the boards in the Downconverter before design is finalized, improving the sensitivity on the higher bands. He/me

What else do you need, there is no specific info available for the downconverter right now.by he s3 itself covers 9khz to 108mhz, the downconverter is an internal module that fits inside the s3 and

At the moment the frequency range is the only information available, almost to me. 73 Francesco, IN3XZP

Thanks for the information Paul. Paul

Not yet, I’ve asked for them and also swl band filters to add to the ham band filters

Paul, Are there S3 plug-in WFM blocking filter(s) available? If so please point to where I might purchase one. I don't see any filters available on the Elad-usa site. *EDIT*: PAUL, PLEASE DISREGARD

HF1/2 9khz to 54mhz Vhf1 54mhz to 108mhz (499.99mhz) Officially radio tunes to 108 but it will go to 500mhz but you would need filters to block WFM signals from appearing above 108 Paul EladUSA

Can someone tell me the frequency coverage of the antenna inputs please. The manual tech spec says HF1+2 inputs are HF+50MHz and the VHF input is VHF band. If anyone can add some frequency detail to

Thanks for reply , but IMHO your answer has near zero info (I read the user manual rev 4 ) .May be those who ask so often can say more ! Pardon me, I'm curious enough f

The downconverter allows coverage above the standard 108mhz all the way up to 2ghz