Yeah, I know I am bumping this old thread, but there was no reply when posted, and I still see the same problem: FDM-SW2 seems to use the local day of week to filter the station memory list, so it

Giovanni, Perfect! I had found the level, but didn't find the division level below. This is a wonderful piece of software. Thank you very much for your efforts! Regards, Bob - N4RFC

And this is the "slider" to set the fft "span" Giovanni, HB9EIK

Hi Bob, this is the fft level "slider", Giovanni - HB9EIK

Hi Bob, if you touch the left side of the screen, on the level numbers, you can choose a reference level. If you touch the left side of the screen, left to waterfall, you can choose a "division

Is there a way to adjust the gain on the BlueDuo spectrum display. 160DB range on that display makes weaker signal pips very hard to see. Is there a way to adjust the range (gain) of the

whew! i use the inexpensive MX-P50M w/my Duo, along with an LDG Z11... 2W in gives ~40W out, depending on band... autotunes nicely thanks to Z11's 60W max, but alas, no auto bandswitching i like that

The HobbyPCB kits are exceptionally good and with the help forum also on the ball.. I built the Hardrock 50 and ATU kits and for my Duo was an ideal partner..but the pleasure of buliding yourself was

Guys, I run my FDM-S2 and -S3 receivers consecutively on the same computer. I can only configure one of the receivers (the first one started) to display the 4 S Meters. I'd like to enable and

Yes, you have to buy the RF Deck board or supply your own. The support kit has supplies that will supply 50-60 volts and a heat sink and heat speader that will work with a number of RF Amps. I see

Hmmmmm, I did not catch that, yea even pricier…. Regards, Jim Allen jim.allen60@...

Don't you then have to buy the $500 RF amp board too?

Just got this today, This is a HF RF amp that works with the Elad 5 watts in 500 watts out with an antenna tuner… It’s a bit pricy at $1,200.00 Regards, Jim Allen jim.allen60@...

Just a note that the Hobby PCM Hardrock 500 Power Amplifier Support Kit is now available for sale. The support kits contains everything you need to home brew a 5w to 500w amplifier. I have completed

Hi John, I am happy for you. I should have guessed a firmware problem. It is indeed a sweet combination. Really it's a top-of-line $2,500 transceiver when all put together which can be used as a

Am I putting my filters correctly? (Recovered my FDM-DUOr filters for my new S3) Position 1: 500kHz low pass (0-500) Position 2: 1700kHz High-Pass (1700-54000) Position 7: supplied bypass

Thanks for sticking with me, Jim. You inspired me to keep trying! So I have figured it out. You would think that if you bought this combination from someone, they would have been using it. It

Hi John, No, you do not have to connect the USB cables. I unplugged all my USB cables to the computer and changing menu 31 still changes the state of the blue "Coax..." indication below the forward

JIm, thanks for your reply. I have changed menu 31 in the FDM-DUO to 2 antennas, but it doesn't change anything on the DUO-ART screen. I do have the cable connected from the FDM-DUO's EXT-I/O to one

John, To change from CoaxRTX to CoaxRX+TX go to menu #31 on the FDM-DUO and change it from Antenna #1 to Antenna #2. Why? One might assume that the #2 antenna connector is for a second receive only